FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Lamp requirements
5 Information for ballast, ignitor and luminaire design
6 Data sheets
Annex A (normative) - Method of measuring lamp starting
and warm-up characteristics
Annex B (normative) - Method of measuring electrical and
photometrical characteristics (lamps for operation
on 50 Hz or 60 Hz supply frequencies)
Annex C (normative) - Method of test for lumen maintenance
and life
Annex D (informative) - Information for luminaire design
Annex E (normative) - Method of measuring electrical and
photometrical characteristics on low frequency square
wave reference ballast
Annex F (normative) - Spectral analysis of power ripple:
calculation procedure for amplitude spectrum ratio
and guidance
Annex G (informative) - Low frequency square wave
operation
Annex H (informative) - Information for ballast design
Annex I (informative) - Information regarding lamp
performance temperature limits for luminaire
design
Annex J (informative) - ILCOS codes
Annex ZA (normative) - Normative references to
international publications with their corresponding
European publications
Annex ZZA (informative) - Relationship between
this European Standard and the ecodesign
requirements of Commission Regulation (EC)
No 245/2009 aimed to be covered
Annex ZZB (informative) - Relationship between
this European Standard and the ecodesign
requirements of Commission Regulation (EU)
No 1194/2012 aimed to be covered
Annex ZZC (informative) - Relationship between
this European Standard and the energy labelling
requirements of Commission Delegated
Regulation (EU) No 874/2012 aimed to
be covered
Bibliography