EN 61167:2016

European foreword
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Lamp requirements
5 Information for ballast, ignitor and luminaire
  design
6 Data sheets
Annex A (normative) - Method of measuring lamp
        starting and warm-up characteristics
Annex B (normative) - Method of measuring electrical
        and photometrical characteristics (lamps for
        operation on 50 Hz or 60 Hz supply
        frequencies)
Annex C (normative) - Method of test for lumen
        maintenance and life
Annex D (informative) - Information for luminaire
        design
Annex E (normative) - Method of measuring electrical
        and photometrical characteristics on low
        frequency square wave reference ballast
Annex F (normative) - Spectral analysis of power
        ripple: calculation procedure for amplitude
        spectrum ratio and guidance
Annex G (informative) - Low frequency square wave
        operation
Annex H (informative) - Information for ballast design
Annex I (informative) - Information regarding lamp
        performance temperature limits for
        luminaire design
Annex J (informative) - ILCOS codes
Bibliography
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications
Annex ZZA (informative) - Relationship between this
          European Standard and the ecodesign
          requirements of Commission Regulation
          (EC) No 245/2009 aimed to be covered
Annex ZZB (informative) - Relationship between this
          European Standard and the ecodesign
          requirements of Commission Regulation
          (EU) No 1194/2012 aimed to be covered
Annex ZZC (informative) - Relationship between this
          European Standard and the energy labelling
requirements of Commission Delegated Regulation
          (EU) No 874/2012 aimed to be covered
Standard and the ecodesign requirements

IEC 61167:2015 specifies the performance requirements for metal halide lamps for general lighting purposes. This third edition replaces the second edition published in 2011. This third edition constitutes a technical revision. This edition includes the following significant technical changes with respect to the previous edition.a) A set of new lamp data sheets (20 W, 35 W, 50 W, 100 W) is introduced.b) Reference to ILCOS (International lamp coding system) is removed from the lamp data sheets and now located in a new annex.c) Information on outer bulb temperature (and in some cases also on pin temperature and temperature adjacent to cap) is replaced with an explanation on differences in manufacturers' construction; this explanation is given in detail in a new annex.