• CEI EN 62811 : 2016

    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

    AC AND/OR DC-SUPPLIED ELECTRONIC CONTROLGEAR FOR DISCHARGE LAMPS (EXCLUDING FLUORESCENT LAMPS) - PERFORMANCE REQUIREMENTS FOR LOW FREQUENCY SQUAREWAVE OPERATION

    Available format(s):  Hardcopy, PDF

    Superseded date:  21-03-2019

    Language(s):  English

    Published date:  01-01-2016

    Publisher:  Comitato Elettrotecnico Italiano

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    FOREWORD
    INTRODUCTION
    1 Scope
    2 Normative references
    3 Terms and definitions
    4 General notes on tests
    5 Marking
    6 General statement
    7 Starting conditions
    8 Operating conditions
    9 Displacement factor
    10 Supply current
    11 Endurance
    Annex A (normative) - Tests
    Annex B (normative) - Reference ballasts
    Annex C (normative) - Conditions for reference lamps
    Annex D (normative) - Control interface for controllable
            controlgear
    Annex E (normative) - Spectral analysis of power ripple:
            calculation procedure for amplitude spectrum ratio
            and guidance
    Annex F (normative) - Open circuit voltage method of
            measurement for pulse ignition
    Bibliography
    Annex ZA (normative) - Normative references to international
             publications with their corresponding European
             publications

    Abstract - (Show below) - (Hide below)

    Defines performance requirements for electronic controlgear for use on a.c. and/or d.c. supplies up to 1000 V and/or a.c. supplies up to 1000 V at 50 Hz or 60 Hz, associated with discharge lamps, as specified in IEC 61167, which have information for low frequency square wave operation, where the frequency range of the low frequency is from 70 Hz to 400 Hz.

    General Product Information - (Show below) - (Hide below)

    Committee CT 34
    Development Note Classificazione CEI 34-154. (03/2016)
    Document Type Standard
    Publisher Comitato Elettrotecnico Italiano
    Status Superseded
    Superseded By

    Standards Referencing This Book - (Show below) - (Hide below)

    IEC 61347-1:2015 RLV Lamp controlgear - Part 1: General and safety requirements
    EN 61000-4-14:1999/A2:2009 ELECTROMAGNETIC COMPATIBILITY (EMC) - PART 4-14: TESTING AND MEASUREMENT TECHNIQUES - VOLTAGE FLUCTUATION IMMUNITY TEST FOR EQUIPMENT WITH INPUT CURRENT NOT EXCEEDING 16 A PER PHASE
    IEC 61167:2015 Metal halide lamps - Performance specification
    EN 61347-1:2015 LAMP CONTROLGEAR - PART 1: GENERAL AND SAFETY REQUIREMENTS (IEC 61347-1:2015)
    IEC 61347-2-12:2005+AMD1:2010 CSV Lamp controlgear - Part 2-12: Particular requirements for d.c. or a.c. supplied electronic ballasts for discharge lamps (excluding fluorescent lamps)
    IEC 61000-4-14:1999+AMD1:2001+AMD2:2009 CSV Electromagnetic compatibility (EMC) - Part 4-14: Testing and measurement techniques - Voltage fluctuation immunity test for equipment with input current not exceeding 16 A per phase
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective