CEN/TS 13547:2006

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Requirements
  4.1 Classification
  4.2 Design
  4.3 Functional characteristics
5 Test procedures
  5.1 Production pressure testing
  5.2 Seat leakage rates
6 Declaration of compliance
7 Designation
8 Marking
  8.1 Mandatory markings
  8.2 Supplementary markings
  8.3 Omission of markings
9 Preparation for storage and transportation
  9.1 Protection
  9.2 Obturator position
  9.3 Body ends
Annex A (normative) Materials
Annex B (normative) Pressure/temperature ratings
Annex C (normative) Determination of angular movement of
        operating element - Method of test
      C.1 General
      C.2 Test method
      C.3 Alternative test
Bibliography

This document applies to copper alloy ball valves for general use having, flanged, threaded, capillary or compression or loose nut/union body ends.This document does not apply to copper alloy ball valves for drinking water applications.This document specifies the design and performance requirements including materials, pressure/temperature ratings for the shell and body seats, dimensions, test procedures and marking.For some specific fields of application, for example gas, valves to this document can be used provided the requirements of the relevant performance standards are met. Approval by the relevant regulatory body may be required.The range of nominal sizes is DN 6 to DN 300 and of nominal diameters 6 mm to 110 mmThe range of pressure designations covered is PN 6 ; PN 10 ; PN 16 ; PN 20 ; PN 25 ; PN 32 ; PN 40 ; PN 63 ; Class 150 and Class 300.For the applicability of each nominal size/diameter and each pressure designation to the different types of valve end, see 4.1.