CLC/TS 50131-2-5:2004

1 Scope
2 Normative references
3 Definitions and abbreviations
4 Functional requirements
   4.1 Indication signal or messages
   4.2 Detection
   4.3 Operational requirements
   4.4 Immunity of the individual technologies to
        incorrect operation
   4.5 Tamper security
   4.6 Electrical requirements
   4.7 Environmental classification and conditions
5 Marking, identification and documentation
   5.1 Marking and identification
   5.2 Documentation
6 Testing
   6.1 General test conditions
   6.2 Basic detection test
   6.3 Walk testing
   6.4 Verification of detection performance
   6.5 Switch-on delay, time interval between signals and
        indication of detection
   6.6 Fault condition signals or messages: self tests
   6.7 Immunity to incorrect operation
   6.8 Tamper security
   6.9 Electrical tests
   6.10 Environmental classification and conditions
   6.11 Marking and documentation
Annex A (normative) Format of standard test magnets
Annex B (normative) General test matrix
Annex C (normative) Walk test matrix
Annex D (normative) Procedure for standard target calculations
Annex E (informative) Basic detection target for the basic
                      test of detection capability
Annex F (informative) Calibration heat source
Annex G (normative) Calibration of the standard walk test targets
Annex H (informative) Equipment for walk test velocity control
Annex J (informative) Immunity to visible and near infrared
                      radiation: calibration of the light source
Annex K (informative) List of small tools suitable for testing
                      immunity of casing to attack
Annex L (informative) Test for resistance to reorientation of
                      adjustable mountings
Figures
Tables

Provides security grades 1-4 (see EN 50131-1), specific or non-specific wired or wire-free combined passive infrared and ultrasonic detectors, and is covered by environmental classes 1-3 (see EN 50130-5).