DEFSTAN 02-536/2(2003) : 2003
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
REQUIREMENTS FOR STATIC CONVERSION EQUIPMENT FOR POWER SERVICES
28-02-2023
12-01-2013
TITLE PAGE
SCOPE
FOREWORD
Sponsorship
Conditions of Release
Categories of Defence Standard
Related Documents
Health and Safety
Additional Information
CONTENTS
SECTION 1 - PERFORMANCE SPECIFICATION
1.1 Performance
1.1.1 General
SECTION 2 - NATIONAL/INTERNATIONAL REGULATIONS
2.1 Warning Signs
SECTION 3 - MILITARY STANDARDS/REQUIREMENTS
3.1 Environmental Considerations
3.1.1 Self-Induced Noise and Vibration
3.1.2 Permissible Temperature Rises
3.1.3 Equipment Cooling
3.1.4 Electromagnetic Compatibility
3.1.5 Reliability and Maintainability
3.2 Information to be Supplied when Tendering
3.2.1 Tender Drawings
3.2.2 Additional Information
3.3 Drawings
3.3.1 Approval Drawings
3.3.2 Delegated Approval
3.4 Marking
3.5 Spares
3.6 Testing
3.6.1 New Design
3.6.2 Modifications
3.6.3 Pre-production Equipment
3.6.4 Production Tests
3.6.5 Temperature Rise Test
3.6.6 Efficiency
3.6.7 Output with Cooler Inoperative
3.6.8 Steady State Voltage/Load Characteristics
3.6.9 Voltage Balance
3.6.10 Phase Displacement
3.6.11 Ripple or Waveform of Voltage
3.6.12 Voltage Modulation
3.6.13 Voltage Range
3.6.14 Steady State Frequency Characteristics
3.6.15 Frequency Modulation
3.6.16 Frequency Range
3.6.17 Voltage Transient Response
3.6.18 Short Circuit Tests
3.6.19 Operation of Protective Devices
3.6.20 Effect of Supply Interruptions
3.6.21 Self-Induced Airborne Noise and Vibration
3.6.22 Electromagnetic Compatibility
3.6.23 Tilt Test
3.6.24 Insulation Resistance
3.6.25 Parallel Operation
3.6.26 Electromagnetic Pulse and Initial
Nuclear Radiation
SECTION 4 - DESIGN REQUIREMENTS/GUIDANCE
4.1 Construction
4.1.1 Construction of Enclosures
4.1.2 Components
4.1.3 Accessibility of Rectifiers
4.1.4 Ventilation Grilles
4.1.5 Closed Air Circuit Water Cooled Equipment
4.1.6 Pumps and Fans
4.2 Power Supplies
4.2.1 Input Supply
4.2.2 Output
4.2.3 Parallel Running
4.3 Control and Protection
4.3.1 Protection Principles
4.3.2 Voltage and Frequency Protection
4.3.3 Short Circuit and Overcurrent Protection
4.3.4 Control Principles
4.3.5 Voltage Control
4.3.6 Frequency Control
4.3.7 Control of Motor Auxiliaries
4.3.8 Indication Circuits
4.3.9 Microprocessors and Built-in-Test
SECTION 5 - CORPORATE EXPERIENCE & KNOWLEDGE
5.1 Equipment Cooling
ANNEX A - RELATED DOCUMENTS
ANNEX B - ABBREVIATIONS AND DEFINITIONS
ANNEX C - PROCUREMENT CHECK LIST
ALPHABETICAL INDEX
Applicable to particular requirements for the design and performance of Static Conversion Equipment for HM Surface Ships and Submarines.
| DevelopmentNote |
Supersedes DEFSTAN 02-536/1(2000) & DEFSTAN 07-230/1(2000) (07/2003) Supersedes DEFSTAN 07-231/1(2000). (07/2004) This standard is obsolescent because it is no longer required for procurement of new equipment but is retained for maintenance purposes in support of existing in-service equipment. (05/2016)
|
| DocumentType |
Standard
|
| PublisherName |
UK Ministry of Defence Standards
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| DEFSTAN 02-636/1(2000) : 2000 | REQUIREMENTS FOR AC AND DC STARTING AND CONTROL GEAR CATEGORY 2 |
| DEFSTAN 02-529(PT2)/1(2000) : 2000 | NUCLEAR HARDENING GUIDE - PART 2: ELECTRICAL INSTALLATION IN SURFACE SHIPS |
| DEFSTAN 08-108(PT1)/1(2000) : 2000 | NUCLEAR HARDENING GUIDE - CATEGORY 1 - PART 1: HARDENING AGAINST NUCLEAR EMP AND INR |
| DEFSTAN 08-123/1(2000) : 2000 | REQUIREMENTS FOR THE DESIGN AND TESTING OF EQUIPMENTS TO MEET ENVIRONMENTAL CONDITIONS - CATEGORY 2 |
| DEFSTAN 08-109/2(2001) : 2001 | REQUIREMENTS FOR THE DESIGN OF ELECTRICAL SUPPLY AND DISTRIBUTION SYSTEMS IN SURFACE SHIPS AND SUBMARINES - CATEGORY 1 |
| DEFSTAN 59-41(PT3)/5(1995) : 1995 | ELECTROMAGNETIC COMPATIBILITY - PART 3: TECHNICAL REQUIREMENTS TEST METHODS AND LIMITS |
| DEFSTAN 07-226/2(2001) : 2001 | REQUIREMENTS FOR ELECTRICAL TESTING OF EQUIPMENT - CATEGORY 2 |
| DEFSTAN 59-41(PT1)/7(2002) : 2002 | ELECTROMAGNETIC COMPATIBILITY - PART 1: INTRODUCTION AND GUIDE TO THE SPECIFICATION AND SELECTION OF EMC REQUIREMENTS |
| DEFSTAN 08-105/1(2000) : 2000 | REQUIREMENTS FOR HEAT EXCHANGERS - CATEGORY 2 |
| DEFSTAN 02-723/1(2000) : 2000 | REQUIREMENTS FOR MARKER PLATES |
| DEFSTAN 02-694/1(2000) : 2000 | GUIDE TO THE PREPARATION OF PRODUCTION TEST SPECIFICATIONS FOR ELECTROTECHNICAL EQUIPMENT |
| DEFSTAN 08-120/1(2000) : 2000 | REQUIREMENTS FOR DETERMINING THE SHOCK STRENGTH OF EQUIPMENT - CATEGORY 2 |
| DEFSTAN 07-224/1(2000) : 2000 | REQUIREMENTS FOR MATERIALS FOR ELECTROTECHNICAL AND NAVAL WEAPONS EQUIPMENT - CATEGORY 2 |
| DEFSTAN 02-784/2(2002) : 2002 | REQUIREMENTS FOR SAFETY SIGNS AND COLOURS |
| DEFSTAN 08-107/2(2001) : 2001 | GENERAL REQUIREMENTS FOR THE DESIGN OF ELECTROMECHANICAL AND NAVAL WEAPON EQUIPMENT - CATEGORY 2 |
| DEFSTAN 02-722/1(2000) : 2000 | REQUIREMENTS FOR THE PREPARATION, IDENTIFICATION AND MANAGEMENTS OF DRAWINGS |
| DEFSTAN 02-51/1(2000) : 2000 | TYPE B SUPPORT PROCEDURES |
| DEFSTAN 02-732/1(2000) : 2000 | THERMOMETERS, LIQUID IN GLASS EXPANSION TYPE AND THERMOMETER POCKETS |
| DEFSTAN 59-36/5(1995) : 1995 | SELECTION OF ELECTRONIC AND ELECTRICAL COMPONENTS FOR USE IN DEFENCE EQUIPMENT |
| DEFSTAN 00-41(PT1)/2(1989) : 1989 | MOD PRACTICES AND PROCEDURES FOR RELIABILITY AND MAINTAINABILITY - PART 1: RELIABILITY DESIGN PHILOSOPHY |
| DEFSTAN 02-48/1(2000) : 2000 | SPARES FOR TYPE 'A' SUPPORT |
| DEFSTAN 07-256/1(2000) : 2000 | REQUIREMENTS FOR STRUCTURE BORNE VIBRATION AND AIRBORNE NOISE TESTING OF WARSHIP EQUIPMENT - CATEGORY 2 |
| BS EN ISO 9000-3:1997 | Quality management and quality assurance standards Guidelines for the application of ISO 9001:1994 to the development, supply, installation and maintenance of computer software |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.