DEFSTAN 22-16/2(2006) : 2006
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
SPECIFICATION FOR THE MANUFACTURE OF 64 MM BORE HOSE ASSEMBLY FOR ABEAM REPLENISHMENT AT SEA FOR USE WITH LUBRICATING OILS, DIESO FUEL AND AVCAT
Hardcopy , PDF
26-03-2007
English
01-01-2006
Foreword
1 Scope
2 Warning
3 Normative References
4 Performance Specification
4.1 Manufacturer's Tests
5 National/International Regulations
6 Military Standards/Requirements
6.1 Manufacture
6.1.1 Quality
6.1.2 Method
6.1.3 Construction
6.1.4 House Markings
6.1.5 Dimensions and Tolerances
6.2 Installation On-board Ships
6.2.1 Installation on Receiving Ships
6.2.2 Hose Service Life
6.2.3 Acceptance of Hoses
6.2.4 Marking of Hoses on Receiving Ships
6.2.5 Stowage On-board
6.2.6 Maintenance
6.2.7 Periodic Testing
6.3 Storage and Issue
6.3.1 Hose Stowage Life
6.4 Identification and Packing
6.5 Oils and Greases
7 Design Requirements/Guidance
7.1 Materials
7.1.1 Lining
7.1.2 Reinforcement
7.1.3 Bonding Wire
7.1.4 Cover and Sleeve
7.1.5 Couplings and Associated Fittings
7.1.6 Binding Wire
7.2 Production Test and Inspection
7.2.1 Visual Inspection
7.2.2 Batch Test
7.2.3 Acceptance Standard
8 Corporate Experience & Knowledge
Annex A - Abbreviations and Definitions
A.1 For the purpose of this Standards the following
abbreviations apply
Annex B - Procurement Check List
Annex C - Testing and Test Report Requirements
C.1 Manufacture's Testing
C.2 Rubber Properties Materials Tests
C.3 Adhesion Test
C.4 Crush Test
C.5 Bend Radius
C.6 Bend Test
C.7 Low Temperature Flexibility Test
C.8 Hydrostatic Tests
C.9 Proof Pressure and Axial Rotation Test
C.10 Electrical Continuity Tests
C.11 Burst Test
C.12 Tensile and Elongation Tests
C.13 Manufacture's Test Report Requirements
Annex D - Tensile and Elongation Test Equipment and Preparation
D.1 Test Equipment
D.2 Preparation of Test Equipment
D.3 Tensile and Elongation Tests
D.4 Test 3
Annex E - Hose Identification Panel
Annex F - Bend Test
F.1 Sample
F.2 Method
F.3 Requirement
Annex G - Low-Temperature Flexibility Test
G.1 Method
Annex H - Method of Measuring the Free Length of a Hose
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.