DIN ISO 10275 E : 2009

Superseded

Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View superseded by

METALLIC MATERIALS - SHEET AND STRIP - DETERMINATION OF TENSILE STRAIN HARDENING EXPONENT

Available format(s):

Superseded date: 01-08-2014

Language(s):

Published date: 12-01-2013

Publisher: German Institute for Standardisation (Deutsches Institut für Normung)

Table of Contents - (Show below) - (Hide below)

National foreword National Annex NA (informative) - Bibliography Introduction 1 Scope 2 Normative references 3 Symbols and designations 4 Principle 5 Test equipment 6 Test pieces 7 Procedure 8 Test report Annex A (informative) - International comparison of symbols                         used in the determination of the                         tensile strain hardening exponent Bibliography

Abstract - (Show below) - (Hide below)

Describes a method for determining the tensile strain hardening exponent n of flat products (sheet and strip) made of metallic materials.

General Product Information - (Show below) - (Hide below)

Document Type	Standard
ISBN
Pages
Published
Publisher	German Institute for Standardisation (Deutsches Institut für Normung)
Status	Superseded
Superseded By	DIN EN ISO 10275 E : 2014

International Equivalents – Equivalent Standard(s) & Relationship - (Show below) - (Hide below)

Equivalent Standard(s)	Relationship
ISO 10275:2007	Identical

Standards Referencing This Book - (Show below) - (Hide below)

DIN EN ISO 9513 E : 2013	METALLIC MATERIALS - CALIBRATION OF EXTENSOMETER SYSTEMS USED IN UNIAXIAL TESTING (ISO 9513:2012 + COR 1:2013)
DIN EN ISO 6892-1:2017-02	METALLIC MATERIALS - TENSILE TESTING - PART 1: METHOD OF TEST AT ROOM TEMPERATURE (ISO 6892-1:2016)
ISO 9513:2012	Metallic materials — Calibration of extensometer systems used in uniaxial testing
ISO 10113:2006	Metallic materials Sheet and strip Determination of plastic strain ratio
ISO 7500-1:2015	Metallic materials Calibration and verification of static uniaxial testing machines Part 1: Tension/compression testing machines Calibration and verification of the force-measuring system

Categories associated with this Standard - (Show below) - (Hide below)

Sub-Categories associated with this Standard - (Show below) - (Hide below)

Sorry this product is not available in your region.

Add To Cart