EN 10131:2006

Foreword
1 Scope
2 Normative references
3 Terms and Definitions
4 Designation
5 Condition of delivery
6 Tolerances on thickness
7 Tolerances on width
   7.1 General
   7.2 Sheet and wide strip
   7.3 Slit wide strip of width less than 600 mm
8 Tolerances on length
9 Tolerances on flatness
   9.1 General
   9.2 Steel grades with specified minimum yield strength
       Re < 260 Mpa
   9.3 Steel grades with specified minimum yield strength
       260 MPa <= Re < 340 Mpa
   9.4 Steel grades with specified minimum yield strength
       Re >= 340 MPa
10 Tolerances on out-of-squareness
11 Tolerances on edge camber
12 Superimposition of dimensions
Bibliography

This European Standard applies to cold rolled uncoated and electrolytically zinc or zinc-nickel coated low carbon and high yield strength steel flat products for cold forming with a minimum thickness of 0,35 mm and, unless otherwise agreed at the time of ordering, less than or equal to 3 mm thick, delivered in sheet, wide strip, slit wide strip or cut lengths obtained from slit wide strip or sheet. The concerned standards are EN 10130, EN 10152, EN 10271, EN 10209, EN 10268 and prEN 10338.

It does not apply to cold rolled strip (rolled width < 600 mm) or to flat cold rolled products for which there is a specific standard, in particular the following:

cold rolled non-grain oriented magnetic steel sheet and strip (EN 10106);

semi-processed steel strip for the construction of magnetic circuits (EN 10126 and 10165);

tinplate and ECCS (EN 10202);

blackplate in coils (EN 10205);

cold rolled uncoated non-alloy mild steel narrow strip for cold forming (EN 10139).