EN 13481-2:2012+A1:2017

European foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Symbols
5 Requirements
6 Test specimens
7 Fitness for purpose
8 Marking, labelling and packaging
Annex A (informative) - Vibration and noise
Annex ZA (informative) - Relationship between this
         European Standard and the Essential
         Requirements of EU Directive 2008/57/EC
Bibliography

This European Standard is applicable to fastening systems in Categories A - E as specified in EN 13481 1:2012, 3.1, for use on concrete sleepers in ballasted track with maximum axle loads, and minimum curve radii as shown in Table 1.Table 1 - Fastening category criteriaCategoryMaximum design axle loadkNMinimum curve radiusmA13040B18080C260150D260400E350150NOTEThe maximum axle load for Categories A and B does not apply to maintenance vehicles.The requirements apply to:-fastening systems which act on the foot and/or web of the rail including direct fastening systems and indirect fastening systems;-fastening systems with dynamic stiffness, kLFA, not less than 50 MN/m;-fastening systems for rail sections included in EN 13674-1 (excluding 49E4) or EN 13674-4.This standard is not applicable to fastening systems for other rail sections, rigid fastening systems or special fastening systems used at bolted joints or glued joints.This standard should only be used for type approval of complete fastening systems.