EN 14314:2015

European foreword
1 Scope
2 Normative references
3 Terms, definitions, symbols, units and abbreviated terms
4 Requirements
5 Test methods
6 Designation code
7 Assessment and Verification of the Constancy of
  Performance (AVCP)
8 Marking and labelling
Annex A (normative) - Factory production control
Annex B (normative) - Determination of the aged value
        of thermal conductivity
Annex C (normative) - Determination of minimum service
        temperature
Annex D (informative) - Additional properties
Annex ZA (informative) - Clauses of this European Standard
         addressing the provisions of the EU Construction
         Products Regulation
Bibliography

This European Standard specifies the requirements for factory made phenolic foam products which are used for the thermal insulation of building equipment and industrial installations with an operating temperature in the range of approximately - 200 °C to + 120 °C.Below an operating temperature of - 50 °C, special tests regarding the suitability of the products in the intended application are advised (e.g. liquefaction of oxygen). Manufacturer's advice should be heeded in all cases.The products are manufactured in the form of blocks, faced or unfaced, boards, pipe sections, segments and prefabricated ware.This European Standard describes product characteristics and includes procedures for testing, evaluation of conformity, marking and labelling.Products covered by this standard are also used in prefabricated thermal insulating systems and composite panels; the performance of systems incorporating these products is not covered.This European Standard does not specify the required level of a given property that should be achieved by a product to demonstrate fitness for purpose in a particular application. The levels required for a given application can be found in regulations and invitations to tender.Products with a declared thermal conductivity greater than 0,050 W/(m·K) at 10 °C are not covered by this standard.This European Standard does not cover products for in situ-insulation (blowing or pouring) or products for the insulation of the building structure.This European Standard does not cover the following acoustical aspects: direct airborne sound insulation and impact noise transmission index.