EN 14758-1:2012

Foreword
1 Scope
2 Normative references
3 Terms, definitions, symbols and abbreviations
4 Material
5 General characteristics
6 Geometrical characteristics
7 Mechanical characteristics of pipes
8 Physical characteristics
9 Performance requirements
10 Sealing rings
11 Marking
Annex A (informative) - General characteristics of
        PP-MD pipes and fittings
Annex B (informative) - Standards for pipes and
        fittings of a material other than PP-MD
Bibliography

This European Standard specifies the requirements for solid-wall pipes, fittings and the system of piping systems made from mineral modified polypropylene materials (PP-MD) in the field of non-pressure underground drainage and sewerage outside the building structure (application area code "U"), and non- pressure underground drainage and sewerage for both buried in ground within the building structure (application area code "D") and outside the building structure.This is reflected in the marking of products by "U" and "UD".It also specifies the test parameters for the test methods referred to in this European Standard.This European Standard covers a range of nominal sizes, a range of pipe series/stiffness classes and gives recommendations concerning colours.NOTE 1It is the responsibility of the purchaser or specifier to make the appropriate selection from these aspects, taking into account their particular requirements and any relevant national regulations and installation practices or codes.In conjunction with Part 2 and Part 3 of EN 14758 (see Foreword) it is applicable to PP-MD pipes and fittings, their elastomeric sealing ring joints and to joints with components of other plastics and non-plastics materials intended to be used for buried piping systems for non-pressure underground drainage and sewerage.This European Standard is applicable to PP-MD pipes with or without an integral socket.NOTE 2The fittings can be manufactured by injection-moulding or be fabricated from pipes and/or mouldings.NOTE 3Requirements and limiting values for application area code "D" are given in Table 4, Table 7 and Table 13.NOTE 4Pipes, fittings and other components conforming to any of the plastics product standards listed in Annex B can be used with pipes and fittings conforming to this European Standard, when they conform to the requirements for joint dimensions given in Clause 6 and to the requirements of Table 13.