EN 14934 : 2007

Foreword
1 Scope
2 Normative references
3 Terms, definitions, symbols, units and abbreviated terms
  3.1 Terms and definitions
  3.2 Symbols, units and abbreviated terms
4 Requirements
  4.1 General
  4.2 For all applications
  4.3 For specific applications
5 Test methods
  5.1 Sampling
  5.2 Conditioning
  5.3 Testing
6 Designation code
7 Evaluation of conformity
8 Marking and labelling
Annex A (normative) Determination of the declared values of
        thermal resistance and thermal conductivity
      A.1 Introduction
      A.2 Input data
      A.3 Declared values
Annex B (normative) Factory Production Control
Annex C (normative) Determination of the aged values of thermal
        resistance and thermal conductivity
      C.1 Scope
      C.2 Procedure for XPS foam without diffusion tight laminates
      C.3 Procedure for XPS foam for use with diffusion tight
          facings on both sides
      C.4 Calculation of aged value
      C.5 Blowing agent
      C.6 Product grouping
Annex D (normative) Determination of behaviour under cyclic
        square wave load
      D.1 Scope
      D.2 Definitions
      D.3 Principle
      D.4 Testing equipment
      D.5 Test specimens
      D.6 Procedure
      D.7 Calculation and expression of results
      D.8 Accuracy of measurement
      D.9 Test report
Annex E (informative) Additional properties
      E.1 General
      E.2 Compressive modulus of elasticity
      E.3 Determination of volume percentage of open and closed cells
      E.4 Determination of shear strength
Annex ZA (informative) Relationship between this European
         Standard and the Essential Requirements of EU
         Directive 89/106/EEC, EU Construction Products Directive
      ZA.1 Scope and relevant characteristics
      ZA.2 Procedures for the attestation of conformity of
           extruded polystyrene foam products
      ZA.3 CE Marking and labelling
Bibliography

This European Standard specifies the requirements for factory made products of extruded polystyrene foam which are used for frost insulation of roads, railways, trafficked areas, light weight fill for reduction of horizontal and vertical earth pressure and other civil engineering applications.