EN 15012:2007

Foreword
Introduction
1 Scope
2 Normative references
3 Terms, definitions and symbols
4 Performance requirements
  4.1 Reaction to fire for applications inside building
  4.2 Dimensional tolerances
  4.3 Tightness (air and liquid)
  4.4 Durability
  4.5 Maximum load for admissible deformation for pipes and
      fittings for applications buried in ground within the
      building structure
  4.6 Dangerous substances
5 Test methods
  5.1 Reaction to fire for applications inside building
  5.2 Dimensional tolerances
  5.3 Tightness
  5.4 Durability
  5.5 Ring stiffness for applications buried in ground within
      the building structure
6 Evaluation of conformity
  6.1 General
  6.2 Initial type testing
  6.3 Factory production control
  6.4 One-off products and products produced in very low
      quantities
Annex A (normative) Mounting and fixing of components in
        the test apparatus according to EN 13823
Annex B (normative) Product standards for soil and waste
        discharge piping systems in plastics materials
Annex C (normative) Standards for assessment of conformity
        for soil and waste discharge piping systems in
        plastics materials
Annex ZA (informative) Clauses of this European Standard
         addressing the provisions of the EU Construction
         Products Directive
  ZA.1 Scope and relevant characteristics
  ZA.2 Procedure for attestation of conformity of plastics
       pipes and fittings
  ZA.3 CE marking and labelling
Bibliography

This document specifies performance requirements for non-pressure plastics pipes, fittings and their joints intended for soil and waste applications:-inside the building (application area code "B"),-buried in ground within the building structure (application area code "BD") and with a diameter greater than or equal to 75 mm,and gives associated test methods for verification and evaluation of conformity with this document.