EN 15101-1:2013

Foreword
1 Scope
2 Normative references
3 Terms, definitions, symbols and abbreviations
4 Requirements
5 Test methods
6 Designation code
7 Evaluation of conformity
8 Marking and labelling
Annex A (normative) - Determination of declared thermal
        resistance and thermal conductivity
Annex B (normative) - Laboratory methods for the
        determination of settlement
Annex C (normative) - Testing for reaction to fire of
        products
Annex D (normative) - Specimen preparation method for the
        water absorption test
Annex E (normative) - Method of test for corrosion
        resistance
Annex F (normative) - Method for determining mould
        fungi resistance
Annex G (normative) - Specimen preparation method for the
        airflow resistance test
Annex H (normative) - Specimen preparation method for
        thermal resistance and thermal conductivity test
Annex I (normative) - Factory production control
Annex J (normative) - Testing for reaction to fire of products
        in standardised assemblies simulating end-use
        application(s)
Annex K (normative) - An example of a performance chart
Annex ZA (informative) - Clause of this European Standard
         addressing the provisions of the EU
         Construction Products Directive
Bibliography

This European Standard specifies requirements for loose-fill cellulose insulation (LFCI) products for the thermal and/or sound insulation of buildings when installed into walls, floors, galleries, roofs and ceilings.This European Standard is a specification for the loose-fill cellulose insulation (LFCI) products before installation.This European Standard describes the product characteristics and includes procedures for testing, marking and labelling and the rules for evaluation of conformity.Products covered by this European Standard may also be used in prefabricated thermal insulation systems and composite panels; the structural performance of systems incorporating these products is not covered.Products with a declared thermal conductivity at 10 °C greater than 0,060 W/(m  K) or a declared thermal resistance lower than 0,25 m2  K/W are not covered by this European Standard.This European Standard does not specify the required level of all properties to be achieved by a product to demonstrate fitness for purpose in a particular application. The required levels are to be found in local regulations or non-conflicting standards.This European Standard does not cover factory made cellulose products placed on the market as bats, mats or boards intended to be used for the insulation of buildings or loose-fill cellulose products for the insulation of building equipment and industrial installations.