• There are no items in your cart

EN 302 217-2-2 : 2.2.1

Current

Current

The latest, up-to-date edition.

FIXED RADIO SYSTEMS; CHARACTERISTICS AND REQUIREMENTS FOR POINT-TO-POINT EQUIPMENT AND ANTENNAS; PART 2-2: DIGITAL SYSTEMS OPERATING IN FREQUENCY BANDS WHERE FREQUENCY CO-ORDINATION IS APPLIED; HARMONIZED EN COVERING THE ESSENTIAL REQUIREMENTS OF ARTICLE 3.2 OF THE R&TTE DIRECTIVE

Available format(s)

Hardcopy , PDF

Language(s)

English

€46.74
Excluding VAT

Intellectual Property Rights
Foreword
Introduction
1 Scope
2 References
3 Definitions, symbols and abbreviations
4 Technical requirements specifications
5 Testing for compliance with technical requirements
Annex A (normative) - Frequency bands from 1,4 GHz to 2,7 GHz
Annex B (normative) - Frequency bands from 3 GHz to 11 GHz
        (channel separation up to 30 MHz and 56/60 MHz)
Annex C (normative) - Frequency bands from 3 GHz to 11 GHz
        (channel separation 40 MHz)
Annex D (normative) - Frequency bands 13 GHz, 15 GHz and
        18 GHz
Annex E (normative) - Frequency bands from 23 GHz to 55 GHz
Annex Ea (normative) - Frequency bands from 71 GHz to 86 GHz
Annex F (normative) - Definition of equivalent data rates
        for packet data, PDH/SDH and other signals on
        the traffic interface
Annex G (normative) - Test report in relation to flexible
        systems applications
Annex H (normative) - HS Requirements and conformance
        Test specifications Table (HS-RTT)
Annex I (informative) - Impact of power control (ATPC and/or RTPC),
        mixed-mode and bandwidth adaptive operation on spectrum
        mask and link design requirements
Annex J (informative) - Typical interference sensitivity behaviour
        for frequency planning purpose
Annex K (informative) - Bibliography
Annex L (informative) - Change History
History

Describes the essential requirements for point- to-point Digital Fixed Radio Systems (DFRS) operating in frequency division full duplex (FDD) in frequency bands, where co-ordinated link-by-link frequency planning is applied.

Committee
ATTM TM4
DocumentType
Standard
Pages
107
PublisherName
European Telecommunications Standards Institute
Status
Current

TR 103 053 : 1.1.1 FIXED RADIO SYSTEMS; PARAMETERS AFFECTING THE SIGNAL-TO-NOISE RATIO (SNR) AND THE RECEIVER SIGNAL LEVEL (RSL) THRESHOLD IN POINT-TO-POINT RECEIVERS; THEORY AND PRACTICE
EN 301 390 : 1.3.1 FIXED RADIO SYSTEMS; POINT-TO-POINT AND MULTIPOINT SYSTEMS; UNWANTED EMISSIONS IN THE SPURIOUS DOMAIN AND RECEIVER IMMUNITY LIMITS AT EQUIPMENT/ANTENNA PORT OF DIGITAL FIXED RADIO SYSTEMS
I.S. EN 301 489-4:2009 ELECTROMAGNETIC COMPATIBILITY AND RADIO SPECTRUM MATTERS (ERM) - ELECTROMAGNETIC COMPATIBILITY (EMC) STANDARD FOR RADIO EQUIPMENT AND SERVICES - PART 4: SPECIFIC CONDITIONS FOR FIXED RADIO LINKS, BROADBAND DATA TRANSMISSION SYSTEM BASE STATIONS, ANCILLARY EQUIPMENT AND SERVICES
TR 102 243-1 : 1.2.1 FIXED RADIO SYSTEMS; REPRESENTATIVE VALUES FOR TRANSMITTER POWER AND ANTENNA GAIN TO SUPPORT INTER- AND INTRA-COMPATIBILITY AND SHARING ANALYSIS; PART 1: DIGITAL POINT-TO-POINT SYSTEMS
TR 103 103 : 1.1.1 FIXED RADIO SYSTEMS; POINT-TO-POINT SYSTEMS; ATPC, RTPC, ADAPTIVE MODULATION (MIXED-MODE) AND BANDWIDTH ADAPTIVE FUNCTIONALITIES; TECHNICAL BACKGROUND AND IMPACT ON DEPLOYMENT, LINK DESIGN AND COORDINATION
TR 103 820 : 1.1.1 FIXED RADIO SYSTEMS; ENERGY EFFICIENCY METRICS AND TEST PROCEDURES FOR POINT-TO-POINT FIXED RADIO SYSTEMS
NF EN 302217-4-1 : 2010 FIXED RADIO SYSTEMS - CHARACTERISTICS AND REQUIREMENTS FOR POINT-TO-POINT EQUIPMENT AND ANTENNAS - PART 4-1: SYSTEM-DEPENDENT REQUIREMENTS FOR ANTENNAS
TR 103 263 : 1.2.1 SYSTEM REFERENCE DOCUMENT (SRDOC); COGNITIVE RADIO TECHNIQUES FOR SATELLITE COMMUNICATIONS OPERATING IN KA BAND
NF EN 302217-4-2 : 2010 FIXED RADIO SYSTEMS - CHARACTERISTICS AND REQUIREMENTS FOR POINT-TO-POINT EQUIPMENT AND ANTENNAS - PART 4-2: ANTENNAS - HARMONIZED EN COVERING THE ESSENTIAL REQUIREMENTS OF ARTICLE 3.2 OF THE R&TTE DIRECTIVE

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.