EN 302 326-1 : 1.2.2

Intellectual Property Rights
Foreword
0 Introduction
  0.1 General
  0.2 Technology features of multipoint systems
  0.3 The licensing authority of the national administrations
1 Scope
  1.1 Multipoint radio systems
  1.2 Frequencies
  1.3 Access methods
  1.4 Equivalent Modulation Order (EMO) and related capacity
  1.5 Duplex methods
  1.6 Asymmetric MP implementations
  1.7 Antenna types
  1.8 Interoperability requirements
2 References
3 Definitions, symbols and abbreviations
  3.1 Definitions
  3.2 Symbols
  3.3 Abbreviations
  3.4 Equipment classification conventions
4 General system architecture
  4.1 General architecture
  4.2 Point-to-Multipoint architectures
  4.3 Mesh (or MP-MP) architectures
  4.4 Antenna types
  4.5 Antenna type - station type combinations
5 Frequency bands and channel plans
  5.1 Frequency bands
  5.2 Channel arrangements and block assignment
6 Profiles and requirements
  6.1 Profiles
  6.2 RF reference architecture
  6.3 Environmental Profile
  6.4 Main requirements for equipment
  6.5 Main requirements for antennas
7 Complementary requirements
  7.1 General
  7.2 System design considerations
  7.3 Interfaces
  7.4 Environmental and mechanical conditions
Annex A (normative): Equipment Classification (EqC)
      A.1 Rationale
      A.2 EqC as a means of identifying a consistent parameter
          set for equipment compliance
Annex B (informative): Relationship between superseded standards
        and Equipment Classification (EqC) of equipment profiles
Annex C (informative): Receiver selectivity and noise figure
Annex D (informative): Traffic path characteristics
      D.1 Synchronization of traffic interfaces
      D.2 Round trip delay
      D.3 Voice coding methods
      D.4 Transparency
Annex E (informative): Typical reference model for BER, MGBR and EMO
      E.1 General
      E.2 Interface X'[1] to X'[N]
      E.3 Payload processing block
      E.4 Multiple access block
      E.5 Outer error correcting block
      E.6 Inner error correcting block
      E.7 Modulator
      E.8 Choice of reference point for BER, MGBR and EMO
      E.9 Examples
Annex F (informative): Mixed-mode operation
      F.1 Introduction
      F.2 General description of mixed-mode systems
      F.3 Historical derivation of transmit spectrum masks
      F.4 Rationale for Multipoint transmit masks
      F.5 Essential requirements for transmitters and receivers
          operating in mixed-mode
Annex G (informative): Application of this multi-part deliverable
Annex H (informative): Notification of Interfaces under article
        4.1 of the R&TTE Directive
      H.1 Applicability of TCAM-RIG format of Radio interface
          specifications to Fixed Services
      H.2 Proposed list of radio interface specifications for
          Fixed Services
Annex I (informative): Bibliography
History

Applies to fixed digital MultiPoint (MP) radio systems, where multipoint encompasses both Point-to-MultiPoint (P-MP) and MultiPoint-to-MultiPoint (MP-MP) network architectures.