EN 61000-5-5:1996

Introduction
1 Scope
2 Normative references
3 Definitions
4 Specifications of protective devices for
      conducted disturbance
4.1 General
4.2 Gas discharge tubes
4.3 Metal oxide varistors (MOV)
4.4 Expulsion-type arresters
4.5 Non-linear resistor type arresters
4.6 Avalanche-junction transient voltage suppressors
      (protective diodes)
4.7 Filters
4.8 Protection circuits
4.9 Safety arresters
4.10 Coaxial r.f. - circuit protectors
Annexes
A (informative) Survey of generic protection circuits
      and their application in surge protection
B (informative) A method of measuring the inductance
      of two-lead voltage limiting devices
C (informative) Survey on safety arresters and related
      safety philosophy
D (informative) A method of measuring the input
      impedance of mains filters
E (informative) Bibliography
ZA (normative) Normative references to International
      publications with their corresponding European
      publications

This part of 61000-5 defines how protective devices for conducted disturbance proposed for HEMP protection shall be specified. It is intended to be used for the harmonization of existing or future specifications issued by protective device manufacturers, electronic equipment manufacturers, administrations and other ultimate buyers. Performance requirements shall be given in future IEC documents. This section covers protective devices currently being used for protection against induced HEMP transients on signal and low voltage power lines (nominal voltage up to 1 kV a.c.). General information can be applied also to high voltage lines. However, in these cases, the additional requirements for the protection levels of existing lightning arresters (especially gapless MO-arresters) are under consideration.