EN IEC 62613-1:2018

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 General
6 Classification
7 Marking
8 Dimensions
9 Protection against electric shock
10 Provision for Earthing
11 Terminals and terminations
12 Locking devices and interlocks
13 Resistance to ageing of rubber and thermoplastic material
14 General construction
15 Construction of socket-outlets and ship inlets
16 Construction of ship connectors
17 Construction of plugs
18 Degrees of protection
19 Insulation resistance, dielectric withstand and partial
   discharge tests
20 Normal operation
21 Temperature rise
22 Flexible cables and their connection
23 Mechanical strength
24 Screws, current-carrying parts and connections
25 Resistance to heat, to fire and to tracking
26 Corrosion and resistance to rusting
27 Conditional short-circuit current withstand test
28 Electromagnetic compatibility
Bibliography
Annex ZA (normative) - Normative references to
         international publications with their
         corresponding European publications

The purpose of the IEC/ISO/IEEE 80005-1 is to define requirements that allow compliant ships to connect to compliant high-voltage shore power supplies through a compatible shore-to-ship connection.IEC 62613 has been written to address the needs of 80005-1 in terms of plugs, socket-outlets, ship connectors and ship inlets (herein referred to as "accessories") to deliver electrical power to ships in ports. IEC 62613 applies to accessories with-three phases and earth with pilot contacts, -one single pole for neutral.These accessories have rated currents not exceeding 500 A and rated operating voltages not exceeding 12 kV 50/60 Hz.These accessories are primarily intended for use outdoors, in a seawater environment, for the shore supply of ships (ship-to-shore connection), in an ambient temperature within the range of 25 °C to +45 °C.NOTE 1: In some countries, other ambient temperatures may prevail and may need to be taken into account.These accessories are not intended for use in hazardous areas. In such locations where special conditions prevail, additional requirements may be necessary.Part 1 of IEC 62613 contains the general requirements;