• I.S. EN 50700:2014

    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

    INFORMATION TECHNOLOGY - PREMISES DISTRIBUTION ACCESS NETWORK (PDAN) CABLING TO SUPPORT DEPLOYMENT OF OPTICAL BROADBAND NETWORKS

    Available format(s):  Hardcopy, PDF

    Superseded date:  22-10-2023

    Language(s):  English

    Published date:  01-01-2014

    Publisher:  National Standards Authority of Ireland

    For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
    Only cited Standards give presumption of conformance to New Approach Directives/Regulations.

    Dates of withdrawal of national standards are available from NSAI.

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    Foreword
    Introduction
    1 Scope
    2 Normative references
    3 Terms, definitions and abbreviations
    4 Conformance
    5 Structure of PDAN cabling within multi-subscriber
       premises
    6 PDAN cabling performance
    7 Implementation options
    8 Cable requirements
    9 Connecting hardware requirements
    10 Cords
    11 Accommodation of the Subscriber Interface (SI) and
       the Customer Premises Equipment (CPE)
    Annex A (informative) - Broadband infrastructure external to
            multi-subscriber premises
    Bibliography

    Abstract - (Show below) - (Hide below)

    Describes the optical fibre optical fibre access network cabling within multisubscriber premises termed the premises distribution access network (PDAN).

    General Product Information - (Show below) - (Hide below)

    Document Type Standard
    Publisher National Standards Authority of Ireland
    Status Superseded
    Superseded By

    Standards Referencing This Book - (Show below) - (Hide below)

    TR 105 174-2-1 : 1.1.1 ACCESS, TERMINALS, TRANSMISSION AND MULTIPLEXING (ATTM); BROADBAND DEPLOYMENT - ENERGY EFFICIENCY AND KEY PERFORMANCE INDICATORS; PART 2: NETWORK SITES; SUB-PART 1: OPERATOR SITES
    IEC 60825-2:2004+AMD1:2006+AMD2:2010 CSV Safety of laser products - Part 2: Safety of optical fibre communication systems (OFCS)
    EN 50377-7-4:2011 Connector sets and interconnect components to be used in optical fibre communication systems - Product specifications - Part 7-4: LC-PC simplex terminated on IEC 60793-2-50 category B1.1 and B1.3 singlemode fibre with full zirconia ferrule for category C
    EN 50346 : 2002 AMD 2 2009 INFORMATION TECHNOLOGY - CABLING INSTALLATION - TESTING OF INSTALLED CABLING
    EN 50174-1:2009/A2:2014 INFORMATION TECHNOLOGY - CABLING INSTALLATION - PART 1: INSTALLATION SPECIFICATION AND QUALITY ASSURANCE
    PREN 50411-3-8 : DRAFT 2014 FIBRE ORGANIZERS AND CLOSURES TO BE USED IN OPTICAL FIBRE COMMUNICATION SYSTEMS - PRODUCT SPECIFICATIONS - PART 3-8: FIBRE MANAGEMENT SYSTEM, TERMINAL EQUIPMENT BOX TYPE 1 FOR CATEGORY C
    EN 60793-2-50:2016 Optical fibres - Part 2-50: Product specifications - Sectional specification for class B single-mode fibres
    CLC/TR 50510:2012 Fibre optic access to end-user - A guideline to building of FTTX fibre optic network
    EN 50411-3-2:2011 Fibre organisers and closures to be used in optical fibre communication systems - Product specifications - Part 3-2: Singlemode mechanical fibre splice
    TS 105 174-1 : 1.2.1 ACCESS, TERMINALS, TRANSMISSION AND MULTIPLEXING (ATTM); BROADBAND DEPLOYMENT AND ENERGY MANAGEMENT; PART 1: OVERVIEW, COMMON AND GENERIC ASPECTS
    EN 60794-5-10:2014 Optical fibre cables - Part 5–10: Family specification - Outdoor microduct optical fibre cables, microducts and protected microducts for installation by blowing
    EN 61755-2-2 : 2006 FIBRE OPTIC CONNECTOR OPTICAL INTERFACES - PART 2-2: OPTICAL INTERFACE STANDARD SINGLE MODE ANGLED PHYSICALLY CONTACTING FIBRES
    CLC/TR 50173-99-3:2012 Information technology - Generic cabling systems - Part 99-3: Home cabling infrastructures up to 50 m in length to support simultaneous and non simultaneous provision of applications
    EN 50173-3 : 2007 COR 2011 INFORMATION TECHNOLOGY - GENERIC CABLING SYSTEMS - PART 3: INDUSTRIAL PREMISES
    EN 50174-3:2013/A1:2017 INFORMATION TECHNOLOGY - CABLING INSTALLATION - PART 3: INSTALLATION PLANNING AND PRACTICES OUTSIDE BUILDINGS
    EN 61280-4-2:2014 Fibre-optic communication subsystem test procedures - Part 4-2: Installed cable plant - Single-mode attenuation and optical return loss measurement
    EN 50173-1:2011 Information technology - Generic cabling systems - Part 1: General requirements
    EN 50174-2 : 2009 AMD 2 2014 INFORMATION TECHNOLOGY - CABLING INSTALLATION - PART 2: INSTALLATION PLANNING AND PRACTICES INSIDE BUILDINGS
    IEC 61280-4-2:2014 Fibre-optic communication subsystem test procedures - Part 4-2: Installed cable plant - Single-mode attenuation and optical return loss measurement
    IEC 61753-041-2:2014 Fibre optic interconnecting devices and passive components - Performance standard - Part 041-2: Non-connectorized single-mode OTDR reflecting device for category C - Controlled environment
    IEC 60794-5-10:2014 Optical fibre cables - Part 5-10: Family specification - Outdoor microduct optical fibre cables, microducts and protected microducts for installation by blowing
    EN 61755-1:2006/corrigendum:2006 FIBRE OPTIC CONNECTOR OPTICAL INTERFACES - PART 1: OPTICAL INTERFACES FOR SINGLE MODE NON-DISPERSION SHIFTED FIBRES - GENERAL AND GUIDANCE
    EN 60794-5-20 : 2014 Optical fibre cables - Part 5-20: Family specification - Outdoor microduct fibre units, microducts and protected microducts for installation by blowing
    IEC 60793-2-50:2015 Optical fibres - Part 2-50: Product specifications - Sectional specification for class B single-mode fibres
    IEC 60794-5-20:2014 Optical fibre cables - Part 5-20: Family specification - Outdoor microduct fibre units, microducts and protected microducts for installation by blowing
    IEC 61755-2-2:2006 Fibre optic connector optical interfaces - Part 2-2: Optical interface standard single mode angled physically contacting fibres
    EN 50411-6-1:2011 Fibre organisers and closures to be used in optical fibre communication systems - Product specifications - Part 6-1: Unprotected microduct for category S and A
    TS 102 873 : 1.1.1 ACCESS, TERMINALS, TRANSMISSION AND MULTIPLEXING (ATTM); OPTICAL EXTERNAL NETWORK TESTING INTERFACE
    IEC 61754-20:2012 Fibre optic interconnecting devices and passive components - Fibre optic connector interfaces - Part 20: Type LC connector family
    EN 60825-2:2004/A2:2010 SAFETY OF LASER PRODUCTS - PART 2: SAFETY OF OPTICAL FIBRE COMMUNICATION SYSTEMS (OFCS)
    ISO/IEC 14763-3:2014 Information technology Implementation and operation of customer premises cabling Part 3: Testing of optical fibre cabling
    CLC/TR 50173-99-2:2010 Information technology - Implementation of BCT applications using cabling in accordance with EN 50173-4
    EN 50173-5 : 2007 AMD 2 2012 INFORMATION TECHNOLOGY - GENERIC CABLING SYSTEMS - PART 5: DATA CENTRES
    EN 50173-4 : 2007 AMD 2 2012 INFORMATION TECHNOLOGY - GENERIC CABLING SYSTEMS - PART 4: HOMES
    CLC/TR 50173-99-1:2007 Cabling guidelines in support of 10 GBASE-T
    EN 50173-6:2013 Information technology - Generic cabling systems - Part 6: Distributed building services
    IEC 61755-1:2005 Fibre optic connector optical interfaces - Part 1: Optical interfaces for single mode non-dispersion shifted fibres - General and guidance
    EN 61754-20:2012 Fibre optic interconnecting devices and passive components - Fibre optic connector interfaces - Part 20: Type LC connector family
    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective