I.S.EN 60065:2014&AC:2016&A11:2017&AC:2017-01

FOREWORD
INTRODUCTION
1 General
2 Terms and definitions
3 General requirements
4 General test conditions
5 Marking and instructions
6 Hazardous radiations
7 Heating under normal operating conditions
8 Constructional requirements with regard to the protection against electric shock
9 Electric shock hazard under normal operating conditions
10 Insulation requirements
11 Fault conditions
12 Mechanical strength
13 CLEARANCES and CREEPAGE DISTANCES
14 Components
15 TERMINALS
16 External flexible cords
17 Electrical connections and mechanical fixings
18 Mechanical strength of picture tubes and protection against the effects of implosion
19 Stability and mechanical hazards
20 Resistance to fire
Annex A (normative) Additional requirements for apparatus with protection against
splashing water
Annex B (normative) Apparatus to be connected to the TELECOMMUNICATION NETWORKS
Annex C (normative) Band-pass filter for wide-band noise measurement
Annex D (normative) Measuring network for TOUCH CURRENTS
Annex E (normative) Measurement of CLEARANCES and CREEPAGE DISTANCES
Annex F (normative) Table of electrochemical potentials
Annex G (normative) Flammability test methods
Annex H (normative) Insulated winding wires for use without interleaved insulation
(see 8.16)
Annex I (Void)
Annex J (normative) Alternative method for determining minimum CLEARANCES
Annex K (normative) Impulse test generators (see 13.3.4 and Annex J, Clause J.6)
Annex L (normative) Additional requirements for electronic flash apparatus for
photographic purposes
Annex M (informative) Examples of requirements for quality control programmes for
allowing reduced clearances
Annex N (informative) Routine tests
Bibliography

This International Safety Standard applies to electronic apparatus designed to be fed from the MAINS, from a SUPPLY APPARATUS, from batteries or from REMOTE POWER FEEDING and intended for reception, generation, recording or reproduction of audio, video and associated signals.