I.S. EN 60728-5:2016
Current
The latest, up-to-date edition.
CABLE NETWORKS FOR TELEVISION SIGNALS, SOUND SIGNALS AND INTERACTIVE SERVICES - PART 5: HEADEND EQUIPMENT
Hardcopy , PDF
English
01-01-2016
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Dates of withdrawal of national standards are available from NSAI.
National Foreword
FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Terms, definitions, symbols and abbreviations
4 Methods of measurement
5 Performance requirements and recommendations
6 Equipment characteristics required to be met
7 Equipment characteristics required to be published
Annex A (normative) - Definition of the specified test
frequency range for return loss and noise figure
Annex B (informative) - Audio connector for European
system according to IEC 60130-9
Annex C (informative) - Selectivity diagram for adjacent
channel transmission
Annex D (informative) - Differences in some countries
Annex E (normative) - Correction factors for noise
Annex F (informative) - Digital signal level and bandwidth
Annex G (informative) - Minimum frequency distance of
converted satellite signals in the IF range
Annex H (informative) - Measurement errors which occur
due to mismatched equipment
Annex I (normative) - Correction factor for spectrum
Analyzer
Bibliography
Annex ZA (normative) - Normative references to
international publications with their
corresponding European publications
Annex ZB (normative) - Special national conditions
Specifies the characteristics of equipment used in the headends of terrestrial broadcast and satellite receiving systems (without satellite outdoor units and without those broadband amplifiers in the headend as described in IEC 60728-3).
| DevelopmentNote |
Supersedes I.S. EN 50083-5. (01/2010) For CENELEC adoptions of IEC publications, please check www.iec.ch to be sure that you have any corrigenda that may apply. (01/2017)
|
| DocumentType |
Standard
|
| Pages |
204
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Current
|
| Supersedes |
| Standards | Relationship |
| EN 60728-5:2016 | Identical |
| BS EN 60728-5:2016 | Equivalent |
| IEC 60728-11:2016 | Cable networks for television signals, sound signals and interactive services - Part 11: Safety |
| IEC 61169-8:2007 | Radio-frequency connectors - Part 8: Sectional specification - RF coaxial connectors with inner diameter of outer conductor 6,5 mm (0,256 in) with bayonet lock - Characteristic impedance 50 Ω (type BNC) |
| EN 61319-1:1996/A11:1999 | INTERCONNECTIONS OF SATELLITE RECEIVING EQUIPMENT - PART 1: EUROPE |
| EN 50083-9:2002 | Cable networks for television signals, sound signals and interactive services - Part 9: Interfaces for CATV/SMATV headends and similar professional equipment for DVB/MPEG-2 transport streams |
| ISO/IEC 13818-1:2015 | Information technology — Generic coding of moving pictures and associated audio information — Part 1: Systems |
| IEC 60068-2-27:2008 | Environmental testing - Part 2-27: Tests - Test Ea and guidance: Shock |
| ISO/IEC 13818-2:2013 | Information technology — Generic coding of moving pictures and associated audio information — Part 2: Video |
| EN 60068-2-1:2007 | Environmental testing - Part 2-1: Tests - Test A: Cold |
| EN 60068-2-2:2007 | Environmental testing - Part 2-2: Tests - Test B: Dry heat |
| IEC 60728-3:2010 | Cable networks for television signals, sound signals and interactive services - Part 3: Active wideband equipment for cable networks |
| IEC 60130-9:2011 | Connectors for frequencies below 3 MHz - Part 9: Circular connectors for radio and associated sound equipment |
| ETSI EN 300 429 V1.2.1 (1998-04) | Digital Video Broadcasting (DVB); Framing structure, channel coding and modulation for cable systems |
| EN 50083-2:2012/A1:2015 | CABLE NETWORKS FOR TELEVISION SIGNALS, SOUND SIGNALS AND INTERACTIVE SERVICES - PART 2: ELECTROMAGNETIC COMPATIBILITY FOR EQUIPMENT |
| IEC 60244-5:1992 | Methods of measurement for radio transmitters - Part 5: Performance characteristics of television transmitters |
| IEC 60068-2-31:2008 | Environmental testing - Part 2-31: Tests - Test Ec: Rough handling shocks, primarily for equipment-type specimens |
| IEC 60728-2:2010 | Cable networks for television signals, sound signals and interactive services - Part 2: Electromagnetic compatibility for equipment |
| EN 60728-11:2017 | Cable networks for television signals, sound signals and interactive services - Part 11: Safety |
| EN 60068-2-27:2009 | Environmental testing - Part 2-27: Tests - Test Ea and guidance: Shock |
| EN 60728-1:2014 | Cable networks for television signals, sound signals and interactive services - Part 1: System performance of forward paths |
| EN 60068-2-40:1999 | Environmental testing - Part 2: Tests - Test Z/AM: Combined cold/low air pressure tests |
| IEC 60529:1989+AMD1:1999+AMD2:2013 CSV | Degrees of protection provided by enclosures (IP Code) |
| IEC 60068-2-2:2007 | Environmental testing - Part 2-2: Tests - Test B: Dry heat |
| CLC/TR 50083-5-1:2009 | Cable networks for television signals, sound signals and interactive services - Part 5-1: IP gateways and interfaces for headends |
| IEC 61319-1:1995 | Interconnections of satellite receiving equipment - Part 1: Europe |
| ISO/IEC 13818-3:1998 | Information technology — Generic coding of moving pictures and associated audio information — Part 3: Audio |
| IEC 60068-2-1:2007 | Environmental testing - Part 2-1: Tests - Test A: Cold |
| EN 60529:1991/AC:2016-12 | DEGREES OF PROTECTION PROVIDED BY ENCLOSURES (IP CODE) (IEC 60529 EDITION 2.2 CORRIGENDUM 2:2015) |
| EN 60068-2-30:2005 | Environmental testing - Part 2-30: Tests - Test Db: Damp heat, cyclic (12 h + 12 h cycle) |
| IEC 60068-2-14:2009 | Environmental testing - Part 2-14: Tests - Test N: Change of temperature |
| EN 60244-5:1994 | Methods of measurement for radio transmitters - Part 5: Performance characteristics for television transmitters |
| EN 60068-2-14:2009 | Environmental testing - Part 2-14: Tests - Test N: Change of temperature |
| ISO/IEC 13818-4:2004 | Information technology — Generic coding of moving pictures and associated audio information — Part 4: Conformance testing |
| IEC 60728-1:2014 | Cable networks for television signals, sound signals and interactive services - Part 1: System performance of forward paths |
| IEC 61169-2:2007 | Radio-frenquency connectors - Part 2: Sectional specification - Radio frequency coaxial connectors of type 9,52 |
| EN 60068-2-31:2008 | Environmental testing - Part 2-31: Tests - Test Ec: Rough handling shocks, primarily for equipment-type specimens |
| IEC 60068-2-30:2005 | Environmental testing - Part 2-30: Tests - Test Db: Damp heat, cyclic (12 h + 12 h cycle) |
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Important note : Users cannot be edited or removed once added to your Multi user PDF.