I.S. EN ISO 62:2008
Current
The latest, up-to-date edition.
PLASTICS - DETERMINATION OF WATER ABSORPTION
Hardcopy , PDF
English
01-01-2008
For Harmonized Standards, check the EU site to confirm that the Standard is cited in the Official Journal.
Only cited Standards give presumption of conformance to New Approach Directives/Regulations.
Dates of withdrawal of national standards are available from NSAI.
Foreword
Introduction
1 Scope
2 Normative references
3 Principle
4 Apparatus
5 Test specimens
5.1 General
5.2 Square-shaped test specimens for homogeneous
plastics
5.3 Test specimens of reinforced plastics affected by
anisotropic diffusion effects
5.4 Tubular test specimens
5.5 Rod-shaped test specimens
5.6 Specimens cut from finished products, extrusion
compounds, sheets or laminates
6 Test conditions and procedures
6.1 General
6.2 General conditions
6.3 Method 1: Determination of amount of water absorbed
after immersion in water at 23 degrees C
6.4 Method 2: Determination of amount of water absorbed
after immersion in boiling water
6.5 Method 3: Determination of water-soluble matter lost
during immersion
6.6 Method 4: Determination of amount of water absorbed after
exposure to 50% relative humidity
7 Expression of results
7.1 Percentage by mass of water absorbed
7.2 Determination of the water content at saturation and the
water diffusion coefficient using Fick's laws
8 Precision
9 Test report
Annex A (informative) - Correlation between water absorption by
test specimens and Fick's diffusion laws
Annex B (informative) - Precision statement
Bibliography
Specifies a procedure for determining the moisture absorption properties in the "through-the-thickness" direction of flat or curved-form solid plastics.
| Committee |
ISO/TC 61
|
| DocumentType |
Standard
|
| Pages |
28
|
| PublisherName |
National Standards Authority of Ireland
|
| Status |
Current
|
| Supersedes |
| Standards | Relationship |
| NEN EN ISO 62 : 2008 | Identical |
| ISO 62:2008 | Identical |
| DIN EN ISO 62:2008-05 | Identical |
| NS EN ISO 62 : 2ED 2008 | Identical |
| BS EN ISO 62:1999 | Identical |
| EN ISO 62:2008 | Identical |
| UNE-EN ISO 62:2008 | Identical |
| ISO 294-3:2002 | Plastics — Injection moulding of test specimens of thermoplastic materials — Part 3: Small plates |
| ISO 175:2010 | Plastics — Methods of test for the determination of the effects of immersion in liquid chemicals |
| ISO 2818:1994 | Plastics — Preparation of test specimens by machining |
Access your standards online with a subscription
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Important note : Users cannot be edited or removed once added to your Multi user PDF.