IEC 61347-2-6:2000

FOREWORD
INTRODUCTION
1 Scope
2 Normative references
3 Definitions
4 General requirements
5 General notes on tests
6 Classification
7 Marking
      7.1 Mandatory markings
      7.2 Information to be provided, if applicable
8 Protection against accidental contact with live parts
9 Terminals
10 Provisions for earthing
11 Moisture resistance and insulation
12 Electric strength
13 Thermal endurance test for windings
14 Pulse voltages
15 Abnormal conditions
16 Fault conditions
17 Construction
18 Creepage distances and clearances
19 Screws, current-carrying parts and connections
20 Resistance to heat, fire and tracking
21 Resistance to corrosion
Annexes
Figure 1 - Suitable circuit for producing and applying short-
           duration pulses
Figure 2 - Circuit for testing rectifying effect
Table 1 - Long duration pulse voltages
Table 2 - Short-duration pulse voltages (10 mus or less)

This part of IEC 61347 specifies particular safety requirements for d.c. supplied electronic ballasts intended for operation from power sources likely to have attendant transients and surges such as in aircraft.This first edition of IEC 61347-2-6, together with IEC 61347-1, cancels and replaces section five of the first edition of IEC 60924, published in 1990, and constitutes a minor revision.This standard shall be used in conjunction with IEC 61347-1. It was established on the basis of the first edition (2000) of that standard.