IEEE 269-2010 REDLINE
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
IEEE Standard Methods for Measuring Transmission Performance of Analog and Digital Telephone Sets, Handsets, and Headsets
18-02-2020
English
26-08-2010
Important note : Users cannot be edited or removed once added to your Multi user PDF.
1 Overview
2 Normative references
3 Definitions
4 Test equipment and setup
5 Calibration
6 Test procedure for analog sets
7 Test procedures for digital and 4-wire systems
8 Test procedures for Analog 4-wire handsets and
headsets
Annex A (normative) - Ear simulators with flexible
pinnas and positioning devices
Annex B (normative) - Alternative ear simulators,
mouth simulator, and test
fixture
Annex C (normative) - DRP to ERP and related
translations
Annex D (normative) - Hoth room noise
Annex E (normative) - Test signals
Annex F (normative) - Levels
Annex G (normative) - Analysis methods
Annex H (normative) - Loudness rating calculations
Annex I (normative) - Linearity
Annex J (normative) - Receive level, conversational gain,
and frequency response metrics
Annex K (normative) - Linearity
Annex L (normative) - Distortion
Annex M (normative) - Send ambient noise reduction and its
effects on speech quality
Annex N (normative) - Delay
Annex O (normative) - Sidetone echo
Annex P (normative) - Maximum acoustic output (long duration)
- alternate method
Annex Q (normative) - Temporally weighted terminal coupling
loss measurement
Annex R (normative) - Temporally weighted terminal coupling
loss algorithm
Annex S (normative) - Simulated speech generator
Annex T (normative) - TDS sweep with P.50 noise burst
Annex U (normative) - Conditioning for carbon transmitters
Annex V (normative) - Measurements on telephones with amplified
receivers
Annex W (informative) - Useful conversion procedures
Annex X (informative) - Perceptual evaluation of speech quality
(PESQ)
Annex Y (informative) - Loudness balance subjective test
procedures
Presents the techniques for objective measurement of electroacoustic characteristics of analog and digital telephones, handsets and headsets. Application is in the frequency range from 100 Hz to 8500 Hz.
| Committee |
Transmission Access & Optical Systems
|
| DevelopmentNote |
Supersedes IEEE 1206. (03/2006) Amendment 1 to IEEE 269 is available separately, see IEEE 269A. (06/2012)
|
| DocumentType |
Standard
|
| ISBN |
978-0-7381-6223-2
|
| Pages |
173
|
| PublisherName |
Institute of Electrical & Electronics Engineers
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
| CSA T531 : 0 | ACOUSTIC-TO-DIGITAL AND DIGITAL-TO-ACOUSTIC TRANSMISSION REQUIREMENTS FOR ISDN TERMINALS |
| MIL-DTL-15514 Revision G:2016 | Telephone Equipment, Sound Powered Telephone Handset, Headset-Chest Set, and Headset - Chest Set, Noise Attenuating |
| IEEE 661 : 1979 | METHOD FOR DETERMINING OBJECTIVE LOUDNESS RATINGS OF TELEPHONE CONNECTIONS |
| TIA 718 : E2012 ADD 1 2013 | MINIMUM PERFORMANCE SPECIFICATION FOR THE ENHANCED VARIABLE RATE CODEC, SPEECH SERVICE OPTIONS 3, 68, 70, 73 AND 77 FOR WIDEBAND SPREAD SPECTRUM DIGITAL SYSTEMS |
| CSA C22.2 No. 62368-1 : 2014 | AUDIO/VIDEO, INFORMATION AND COMMUNICATION TECHNOLOGY EQUIPMENT - PART 1: SAFETY REQUIREMENTS |
| IEEE/ANSI C63.19-2011 REDLINE | American National Standard Methods of Measurement of Compatibility between Wireless Communications Devices and Hearing Aids |
| EG 202 518 : 1.4.1 | SPEECH AND MULTIMEDIA TRANSMISSION QUALITY (STQ); ACOUSTIC OUTPUT OF TERMINAL EQUIPMENT; MAXIMUM LEVELS AND TEST METHODOLOGY FOR VARIOUS APPLICATIONS |
| CSA T510 : 0 | PERFORMANCE AND COMPATIBILITY REQUIREMENTS FOR TELEPHONE SETS WITH LOOP SIGNALLING |
| IEEE 1652-2008 | IEEE Standard for the Application of Free Field Acoustic Reference to Telephony Measurements |
| MIL-STD-188-190 Base Document:1990 | Methods for Communications Systems Measurements (No S/S Document) |
| CSA C22.2 No. 60950-1 :2007 | INFORMATION TECHNOLOGY EQUIPMENT - SAFETY - PART 1: GENERAL REQUIREMENTS |
| CSA C22.2 No. 60950-1 : 2007 : INC : AMD 1 : 2011 : R2012 | INFORMATION TECHNOLOGY EQUIPMENT - SAFETY - PART 1: GENERAL REQUIREMENTS |
| CSA C22.2 No. 60950-1 : 2007 : INC : AMD 2 : 2014 : R201200 | INFORMATION TECHNOLOGY EQUIPMENT - SAFETY - PART 1: GENERAL REQUIREMENTS |
| CSA C22.2 No. 60950-1 : 2007 : R2012 | INFORMATION TECHNOLOGY EQUIPMENT - SAFETY - PART 1: GENERAL REQUIREMENTS |
| CSA C22.2 No. 60950-1 : 2007 : INC : UPD 1 : 2011 | INFORMATION TECHNOLOGY EQUIPMENT - SAFETY - PART 1: GENERAL REQUIREMENTS |
| CSA C22.2 No. 60950-1 : 2007 : INC : AMD 2 : 2014 : R2016 | INFORMATION TECHNOLOGY EQUIPMENT - SAFETY - PART 1: GENERAL REQUIREMENTS |
| TIA 2000 SERIES : F | INTRODUCTION TO CDMA2000 SPREAD SPECTRUM SYSTEMS |
| 12/30239867 DC : 0 | BS EN 62368-1 - AUDIO/VIDEO, INFORMATION AND COMMUNICATION TECHNOLOGY EQUIPMENT - PART 1: SAFETY REQUIREMENTS |
| IEEE DRAFT C63.19 : 2005 | METHODS OF MEASUREMENT OF COMPATIBILITY BETWEEN WIRELESS COMMUNICATIONS DEVICES AND HEARING AIDS |
| IEEE/ANSI C63.9-2008 | American National Standard for RF Immunity of Audio Office Equipment to General Use Transmitting Devices with Transmitter Power Levels up to 8 Watts |
| IEEE 1206-1994 | IEEE Standard Methods for Measuring Transmission Performance of Telephone Handsets and Headsets |
| ANSI/ASA S3.7 : 2016 | METHOD FOR MEASUREMENT AND CALIBRATION OF EARPHONES |
| 07/30091745 DC : 0 | BS IEC 62368 - AUDIO/VIDEO, INFORMATION AND COMMUNICATION TECHNOLOGY EQUIPMENT - SAFETY - REQUIREMENTS |
| IEEE/ANSI C63.19-2019 | American National Standard -- Methods of Measurement of Compatibility Between Wireless Communications Devices and Hearing Aids |
| IEEE 1329-2010 | IEEE Standard Method for Measuring Transmission Performance of Speakerphones |
| ANSI/ASA S1.1:2013 | ACOUSTICAL TERMINOLOGY |
| IEEE 661 : 1979 | METHOD FOR DETERMINING OBJECTIVE LOUDNESS RATINGS OF TELEPHONE CONNECTIONS |
| IEEE 743-1995 | IEEE Standard Equipment Requirements and Measurement Techniques for Analog Transmission Parameters for Telecommunications |
| TIA/EIA 579 : A1998 | TELECOMMUNICATIONS TELEPHONE TERMINAL EQUIPMENT TRANSMISSION REQUIREMENTS FOR DIGITAL WIRELINE TELEPHONES |
| ANSI S1.4 : 1983 | SPECIFICATION FOR SOUND LEVEL METERS |
| ANSI S1.11 : 2014 | SPECIFICATION FOR OCTAVE-BAND AND FRACTIONAL-OCTAVE-BAND ANALOG AND DIGITAL FILTERS |
| IEC 61094-4:1995 | Measurement microphones - Part 4: Specifications for working standard microphones |
| ISO 3:1973 | Preferred numbers Series of preferred numbers |
| TS 126 132 : 13.2.0 | UNIVERSAL MOBILE TELECOMMUNICATIONS SYSTEM (UMTS); LTE; SPEECH AND VIDEO TELEPHONY TERMINAL ACOUSTIC TEST SPECIFICATION (3GPP TS 26.132 VERSION 14.1.0 RELEASE 14) |
| ANSI/ASA S1.6 : 2016 | PREFERRED FREQUENCIES AND FILTER BAND CENTER FREQUENCIES FOR ACOUSTICAL MEASUREMENTS |
| EG 202 396-3 : 1.5.1 | SPEECH AND MULTIMEDIA TRANSMISSION QUALITY (STQ); SPEECH QUALITY PERFORMANCE IN THE PRESENCE OF BACKGROUND NOISE; PART 3: BACKGROUND NOISE TRANSMISSION - OBJECTIVE TEST METHODS |
| IEEE 1652-2008 | IEEE Standard for the Application of Free Field Acoustic Reference to Telephony Measurements |
| SR TSV 002476 : ISS 1 BULLETIN 1 | CPE COMPATIBILITY CONSIDERATIONS FOR THE VOICEBAND DATA TRANSMISSION INTERFACE |
| IEEE 1329-2010 | IEEE Standard Method for Measuring Transmission Performance of Speakerphones |
| EG 202 396-1 : 1.2.4 | SPEECH AND MULTIMEDIA TRANSMISSION QUALITY (STQ); SPEECH QUALITY PERFORMANCE IN THE PRESENCE OF BACKGROUND NOISE; PART 1: BACKGROUND NOISE SIMULATION TECHNIQUE AND BACKGROUND NOISE DATABASE |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.