• Shopping Cart
    There are no items in your cart

JIS C 60068-2-52:2000

Superseded

Superseded

A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.

View Superseded by

Environmental testing Part 2: Tests - Test Kb: Salt mist, cyclic (sodium, chloride solution)

Available format(s)

Hardcopy , PDF

Superseded date

22-10-2020

Superseded by

JIS C 60068-2-52:2020

Language(s)

English, Japanese

Published date

15-02-2008

€40.52
Excluding VAT

1 - 
2 - 
3 - 
4 - 
5 - 
6 - 
7 - 
8 - 
9 - 
10 - 
11 - 

This Standard is intended for application to electrical electronic and other components or equipment designed to withstand a salt-laden atmosphere, depending on the chosen severity. Salt can degrade the performance of parts manufactured using metallic and/or non-metallic materials. The mechanism of salt corrosion in metallic materials is electrochemical, whereas the degradation effects experienced on non-metallic materials are caused by complex chemical reactions of the salts with the materials involved. The rate at which corrosive action takes place is dependent, to a large extent, on the supply of oxygenated salt solution to the surface of the test specimen, the temperature of the specimen and the temperature and humidity of the environment. Apart from the corrosive effects, this test may be used to indicate deterioration of some non-metallic materials by assimilation of salts. In the following test methods, the period of spraying with the relevant salt solution is sufficient to wet the specimen thoroughly. Because this wetting is repeated after intervals of storage under humid conditions (severities (1) and (2) and -- in some cases severities (3) to (6) ) -- supplemented by storage under a standard atmosphere for testing, it goes some way to reproducing the effects of natural environments. Severities (1) and (2) are intended to be used for testing products which are used in a marine environment, or in close proximity to the sea. Severity (1) should be used to test products which are exposed to the environment for much of their operational life (e.g. ship radar, deck equipment). Severity (2) should be used to test products which may be exposed to the marine environment from time to time but will normally be protected by an enclosure (e.g. navigational equipment which will normally be used on the bridge or in a control room. Additionally, severities (1) and (2) are commonly used as a general corrosion test in component quality assurance procedures. Severities (3) t

DocumentType
Standard
Pages
11
PublisherName
Japanese Standards Association
Status
Superseded
SupersededBy

Reaffirmed 2015 2000(R2015) [20/10/2015]2000 [20/02/2000]89

JIS C 60355:1993 An appraisal of the problems of accelerated testing for atmospheric corrosion
JIS C 60068-1:1993 Environmental testing Part 1: General and guidance

JIS C 2570:1998 Directly heated negative temperature coefficient thermistors
JIS C 9335-2-76:2005 Household And Similar Electrical Appliances - Safety - Part 2-76: Particular Requirements For Electric Fence Energizers
JIS C 9335-2-83:2007 Household And Similar Electrical Appliances - Safety - Part 2-83: Particular Requirements For Heated Gullies For Roof Drainage
JIS F 0812:2006 Maritime Navigation And Radiocommunication Equipment And Systems - General Requirements - Methods Of Testing And Required Test Results
JIS H 8624:1999 Electroplated coatings of Tin-Lead alloys
JIS C 8938:1995 Environmental And Endurance Test Methods For Amorphous Solar Cell Modules
JIS C 6703:2002 Generic specification of crystal filters
JIS C 6703:2008 Crystal filters
JIS C 9335-2-59:2005 Household And Similar Electrical Appliances - Safety - Part 2-59: Particular Requirements For Insect Killers
JIS C 61000-4-14:2004 Electromagnetic Compatibility (emc) - Part 4-14: Testing And Measurement Techniques - Voltage Fluctuation Immunity Test
JIS C 5381-331:2006 Components For Low-voltage Surge Protective Devices - Part 331: Specification For Metal Oxide Varistors (mov)
JIS E 5004-2:2006 Electric Equipment For Rolling Stock - Part 2: Electrotechnical Components - General Rules
JIS C 8917:1998 Environmental and endurance test methods for crystalline solar PV modules
JIS C 6710:2007 Generic specification of crystal controlled oscillators
JIS C 9335-2-82:2005 Household And Similar Electrical Appliances - Safety - Part 2-82: Particular Requirements For Amusement Machines And Personal Service Machines
JIS C 9335-2-78:2005 Household And Similar Electrical Appliances - Safety - Part 2-78: Particular Requirements For Outdoor Barbecues
JIS C 9335-2-84:2005 Household And Similar Electrical Appliances - Safety - Part 2-84: Particular Requirements For Appliances Used With Toilets
JIS C 60068-2-11:1989 Basic environmental testing procedures Part 2: Tests - Test Ka: Salt mist
JIS E 5004-1:2006 Electric Equipment For Rolling Stock - Part 1: General Service Conditions And General Rules
JIS C 2570-1:2006 Directly Heated Negative Temperature Coefficient Thermistors - Part 1: Generic Specification
JIS C 9335-2-40:2004 Household And Similar Electrical Appliances - Part 2-40: Particularrequirements For Electrical Heat Pumps, Air-conditioners And Dehumidifiers
JIS H 8619:1999 Electroplated coatings of tin
JIS C 60068-2-47:2008 Environmental testing Part 2-47: Tests - Mounting of specimens for vibration, impact and similar dynamic tests
JIS C 9335-2-88:2006 Household And Similar Electrical Appliances - Safety - Part 2-88: Particular Requirements For Humidifiers Intended For Use With Heating, Ventilation, Or Air-conditioning Systems
JIS A 1551:1995 Test Method For Automatic Door Systems

Access your standards online with a subscription

Features

  • Simple online access to standards, technical information and regulations.

  • Critical updates of standards and customisable alerts and notifications.

  • Multi-user online standards collection: secure, flexible and cost effective.