NBN EN 201 : 2010

Foreword
0 Introduction
1 Scope
2 Normative references
3 Definitions
4 List of hazards
5 Safety requirements and/or measures
6 Verification of the safety requirements and/or measures
7 Information for use
Annexes
A (normative) Additional requirements for protection
    devices type III
B (informative) Use of proportional valves for the platen
    movement
C (normative) Single acknowledgement system
D (normative) Noise measurement for injection moulding
    machines
E (normative) Size indication of injection moulding
    machines
F (normative) Test block
ZA (informative) Clauses of this European Standard
    addressing essential requirements or other provisions
    of EU Directives

Defines the essential safety requirements for injection moulding machines for processing plastics and/or rubber. Defines safety requirements for interaction between injection moulding machines and ancillary equipment, but not the safety requirements of the ancillary equipment, or design requirements for an exhaust system. Applicable to those machines made after the standard issue date.