NEN EN ISO 14978 : 2006 C1 2008

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Abbreviations
5 Design characteristics
  5.1 General
  5.2 Indicating measuring equipment
  5.3 Material measures
6 Metrological characteristics
  6.1 General
  6.2 Identification, definition and choice of metrological
      characteristics
  6.3 Indicating measuring equipment - identification of
      general metrological characteristics
  6.4 Material measures - Identification of general
      metrological characteristics
7 Types of presentation and types of specifications for
  characteristics
  7.1 General
  7.2 Presentation of characteristic curves - Fixed and
      floating zero
  7.3 Presentation of a characteristic - Statistical
  7.4 Specifications for single-value metrological
      characteristics
  7.5 Specification for metrological characteristics
      defined in a range
  7.6 Specification for metrological characteristics defined
      in a two- or three-dimensional range
8 Calibration of metrological characteristics
  8.1 Manufacturer and supplier of measuring instruments
  8.2 User of measuring instruments
  8.3 Measurement uncertainty
9 Marking
Annex A (normative) General minimum requirements and
        guidance for clauses in GPS standards for
        specific measuring equipment
Annex B (informative) Data sheet for measuring equipment
        requirements
Annex C (normative) Relation to the GPS matrix model
Bibliography

Describes the general requirements, terms and definitions of characteristics of simple GPS measuring equipment, e.g. micrometers, dial gauges, callipers, surface plates, height gauges, gauge blocks, but not necessarily excluding more complicated equipment.