ONORM EN ISO 293 : 2005
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
PLASTICS - COMPRESSION MOULDING TEST SPECIMENS OF THERMOPLASTIC MATERIALS
19-07-2023
12-01-2013
National foreword
0 Introduction
1 Scope and field of application
2 References
3 Definitions
4 Apparatus
5 Procedure
6 Inspection of the moulded specimens or sheets
7 Test report
Figure 1 - Types of flash ("picture frame") moulds
Figure 2 - Positive-type mould
Table - Cooling methods
Describes the general principles and the procedures to be followed with thermoplastics in the preparation of compression-moulded test specimens and sheets from which test specimens may be machined or stamped.
| Committee |
TC 074
|
| DocumentType |
Standard
|
| PublisherName |
Osterreichisches Normungsinstitut/Austrian Standards
|
| Status |
Superseded
|
| SupersededBy |
| Standards | Relationship |
| SN EN ISO 293 : 2003 | Identical |
| I.S. EN ISO 293:2005 | Identical |
| UNE-EN ISO 293:2006 | Identical |
| NS EN ISO 293 : 2ED 2005 | Identical |
| NBN EN ISO 293 : 2005 | Identical |
| EN ISO 293:2005 | Identical |
| DIN EN ISO 293:2005-10 | Identical |
| ISO 293:2004 | Identical |
| UNI EN ISO 293 : 2005 | Identical |
| NF EN ISO 293 : 2005 | Identical |
| BS EN ISO 293 : 2005 | Identical |
| NEN EN ISO 293 : 2005 | Identical |
| OVE/ONORM EN 60695-2-13 : 2015 | FIRE HAZARD TESTING - PART 2-13: GLOWING/HOT-WIRE BASED TEST METHODS - GLOW-WIRE IGNITION TEMPERATURE (GWIT) TEST METHOD FOR MATERIALS (IEC 60695-2-13:2010 + A1:2014) |
| OVE/ONORM EN 60695-11-10 : 2014 AC 2015 | FIRE HAZARD TESTING - PART 11-10: TEST FLAMES - 50 W HORIZONTAL AND VERTICAL FLAME TEST METHODS (IEC 60695-11-10:2013) |
| OVE/ONORM EN 60695-2-12 : 2015 | FIRE HAZARD TESTING - PART 2-12: GLOWING/HOT-WIRE BASED TEST METHODS - GLOW-WIRE FLAMMABILITY INDEX (GWFI) TEST METHOD FOR MATERIALS (IEC 60695-2-12:2010 + A1:2014) |
| ISO 4287:1997 | Geometrical Product Specifications (GPS) — Surface texture: Profile method — Terms, definitions and surface texture parameters |
| ISO 286-1:2010 | Geometrical product specifications (GPS) ISO code system for tolerances on linear sizes Part 1: Basis of tolerances, deviations and fits |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.