Skip to content
Please enter a keyword to search
  • Preview

    S.R. CEN ISO TS 12181-2:2007

    View superseded by
    Superseded A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
    View superseded by

    GEOMETRICAL PRODUCT SPECIFICATIONS (GPS) - ROUNDNESS - PART 2: SPECIFICATION OPERATORS

    Available format(s):  Hardcopy, PDF

    Superseded date:  18-04-2011

    Language(s):  English

    Published date:  01-01-2007

    Publisher:  National Standards Authority of Ireland

    Add To Cart

    Table of Contents - (Show below) - (Hide below)

    Foreword
    Introduction
    1 Scope
    2 Normative references
    3 Terms and definitions
    4 Complete specification operator
    5 Compliance with specification
    Annex A (informative) Harmonic content of nominally round
                          workpiece
    Annex B (informative) Relation to the GPS matrix model
    Bibliography

    Abstract - (Show below) - (Hide below)

    Gives the complete specification operator for roundness of integral features only and covers complete roundness profiles only, i.e. geometrical characteristics of features of the type circle.

    General Product Information - (Show below) - (Hide below)

    Document Type Standard
    Publisher National Standards Authority of Ireland
    Status Superseded
    Superseded By

    Standards Referencing This Book - (Show below) - (Hide below)

    ISO/TR 14638:1995 Geometrical product specification (GPS) Masterplan
    ISO/TS 17450-2:2002 Geometrical product specifications (GPS) General concepts Part 2: Basic tenets, specifications, operators and uncertainties
    ISO 4287:1997 Geometrical Product Specifications (GPS) — Surface texture: Profile method — Terms, definitions and surface texture parameters
    ISO 10360-1:2000 Geometrical Product Specifications (GPS) — Acceptance and reverification tests for coordinate measuring machines (CMM) — Part 1: Vocabulary
    ISO 14253-1:2017 Geometrical product specifications (GPS) — Inspection by measurement of workpieces and measuring equipment — Part 1: Decision rules for verifying conformity or nonconformity with specifications
    ISO 3274:1996 Geometrical Product Specifications (GPS) — Surface texture: Profile method — Nominal characteristics of contact (stylus) instruments
    ISO 4292:1985 Methods for the assessment of departure from roundness Measurement by two- and three-point methods
    ISO 14660-1:1999 Geometrical Product Specifications (GPS) Geometrical features Part 1: General terms and definitions
    ISO/TS 12181-1:2003 Geometrical Product Specifications (GPS) Roundness Part 1: Vocabulary and parameters of roundness
    View more information

    • Access your standards online with a subscription

      Features

      • Simple online access to standards, technical information and regulations
      • Critical updates of standards and customisable alerts and notifications
      • Multi - user online standards collection: secure, flexibile and cost effective