S.R. CEN TR 15858:2009

Executive summary
Foreword
1 Introduction
2 Scope
3 Terms and definitions
4 General procedure
5 Basic principles
   5.1 Introduction
   5.2 Construction Product Directive
   5.3 Scope of Mandate M/366
   5.4 Constituents, materials, products
   5.5 Regulations and Directives placing requirements
       on the environment
   5.6 Regulatory levels, RDS classes and sets of RDS
       classes
   5.7 Assessment procedures
   5.8 Combining construction products into a single
       assessment
   5.9 Construction Products covered by Member State
       Regulations but not covered under CPD-ETS
6 Release/emission scenarios
7 Identification of relevant regulated dangerous substances
8 Setting of RDS classes by Product TCs
9 Initial Type Assessment
10 Conformity to a class limit on the basis of a WT procedure
   10.1 General
   10.2 Dossier of information
   10.3 Assessment of the dossier
   10.4 Application of the WT procedure
11 Evaluation of conformity
12 Factory production control of RDSs
   12.1 General
   12.2 Routine control of production
13 Recommended delivery of the proposed system
   13.1 List of mandated RDSs
   13.2 Statistical basis for the system
   13.3 RDS classes and sets of RDS classes
   13.4 WT procedure
   13.5 WFT procedure
   13.6 FT procedure
   13.7 Evaluation of conformity
Annex A (informative) - Implementation of the proposed system
        by a manufacturer of a product
References

Specifies a procedure for assessing construction products with regards to their release/emission of regulated dangerous substances (RDS) into the environment in accordance with Essential Requirement Number 3 of the Construction Products Directive (CPD), as far as these construction products fall under the responsibility of CEN.