SN EN 10029 : 2011

Cooperating organizations
National foreword
Foreword
1. Scope
2. Normative references
3. Definition
4. Information to be supplied by the purchaser
4.1 General
4.2 Options
5. Designation
6. Form of supply
7. Tolerances on dimensions
7.1 Thickness
7.2 Width
7.3 Length
8. Tolerances on shape
8.1 Edge camber and out-of squareness
8.2 Flatness
9. Excess mass
10. Measurements
10.1 Thickness
10.2 Width
10.3 Length
10.4 Edge camber
10.5 Out of squareness
10.6 Flatness
11. Options
Annex A. List of national standards which correspond to
EURONORM 91
National appendix NA (informative)

Describes requirements for tolerances for hot-rolled non-alloy and alloy steel plates including stainless steels with thickness greater than or equal to 3mm and less than or equal to 250mm, width greater than or equal to 600mm, and specified minimum yield strength less than 700 N/mm sq. Does not apply to round plates, sketch plates, chequer or raised-droplet pattern floor plates and wide flats for which other EURONORMS exist. Covers normative references, definition, information to be supplied by the purchaser, designation, form of supply, tolerance on dimensions, tolerances on shape, excess mass, measurements and options.