SN EN 1366-3 : 2009

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Test equipment
5 Test conditions
   5.1 Heating conditions
   5.2 Pressure conditions
6 Test specimen
   6.1 General
   6.2 Size
   6.3 Number
   6.4 Design
        6.4.1 General
        6.4.2 Support conditions for penetrating services
        6.4.3 Pipe end configuration
        6.4.4 Cable end configuration
        6.4.5 Blank penetration seal
        6.4.6 Subsequent addition of services
   6.5 Construction
   6.6 Verification
7 Installation of test specimen
   7.1 General
   7.2 Supporting construction
        7.2.1 General
        7.2.2 Standard supporting constructions
   7.3 Installation of service
   7.4 Installation of penetration seal
   7.5 Multiple test specimens
8 Conditioning
9 Application of instrumentation
   9.1 Thermocouples
        9.1.1 Furnace thermocouples (plate thermometers)
        9.1.2 Unexposed face thermocouples
        9.1.3 Roving thermocouple
   9.2 Integrity measurement
   9.3 Pressure
10 Test procedure
   10.1 General
   10.2 Integrity
   10.3 Insulation
   10.4 Other observations
11 Performance criteria
   11.1 Integrity
   11.2 Insulation
   11.3 Multiple penetrations
12 Test report
13 Field of direct application of test results
Annex A (informative) Explanatory notes
   A.1 General
   A.2 Notes on the scope and application of test results
   A.3 Notes on test conditions
   A.4 Notes on test construction
   A.5 Suggested pipe end configurations for different
        end-uses
   A.6 Notes on test procedure
   A.7 Notes on test criteria
   A.8 Notes on validity of test results
   A.9 Notes on test report
   A.10 Small diameter control cables
Annex B (normative) Standard configuration for cable penetration
                    seals
   B.1 Structure of specimens
   B.2 Deviations from standard specimens
   B.3 Field of direct application
Annex C (normative) Standard configuration and field of direct
                    application for penetration seals for pipes
   C.1 Standard configuration for penetration seals for metal pipes
   C.2 Non-standard configurations
   C.3 Direct field of application

Defines a method of test and criteria for the evaluation of the ability of a penetration sealing system to maintain the fire resistance of a separating element at the position at which it has been penetrated by a service.