UNI EN 13566-2 : 2006

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions, symbols and
  abbreviations
  3.1 Terms and definitions
  3.2 Symbols and abbreviations
4 Pipes at the "M" stage
  4.1 Materials
  4.2 General characteristics
  4.3 Material characteristics
  4.4 Geometrical characteristics
  4.5 Mechanical characteristics
  4.6 Physical characteristics
  4.7 Jointing
  4.8 Marking
5 Fittings at the "M" stage
  5.1 Requirement for fittings
  5.2 Marking
6 Ancillary components
7 Fitness for purpose of the system for pipes and
  fittings at the "I" stage
8 Installation practice
  8.1 Preparatory work
  8.2 Storage, handling and transport
  8.3 Equipment
  8.4 Installation
  8.5 Process-related inspection and testing
  8.6 Lining termination
  8.7 Reconnecting to existing manholes and laterals
  8.8 Final inspection and testing
Annex A (informative) Recommended scheme for assessment
                      of conformity
Annex B (normative) Structured-wall pipes used for
                      continuous pipe lining - Specification
                      of layers
Annex C (normative) Structured-wall pipes used for continuous
                      pipe lining - Determination of residual
                      elongation and leaktightness following
                      application and removal of a specified
                      longitudinal pulling force
Annex D (normative) Structured-wall pipes used for continuous
                      pipe lining - Determination of resistance
                      to application of a specified temporary
                      longitudinal bending radius
Bibliography

Defines requirements and test methods for pipes and fittings which are part of plastics piping systems installed as continuous pipes in the renovation of non-pressure drainage and sewerage networks.