UNI EN 15773 : 2009

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Ordering
   4.1 General
   4.2 Request for quotation
   4.3 Information provision
   4.4 Delivery of product prepared for coating
5 Fabrication
   5.1 Surface condition of the steel
   5.2 Nature and composition of the raw material
   5.3 Welds, markings, labels
   5.4 Deviations of edges and sides
6 Zinc coating and zinc surface
   6.1 Cooling
   6.2 Quality and inspection of the zinc coating
   6.3 Storage, packaging and transport after galvanizing
       or sherardizing
   6.4 Acceptance check
7 Pre-treatment of the zinc surface
   7.1 General
   7.2 Chemical pre-treatment
   7.3 Mechanical pre-treatment (sweep blasting)
8 Powder organic coating layers
   8.1 General
   8.2 Specification of powder organic coating
   8.3 Repair of the coating system
9 Packaging, storage and further movement of finished
   products
10 Installation
11 Inspection of finished products
12 Health and Safety
Annex A (normative) Considerations when designing and
        fabricating items for galvanizing or sherardizing
        and subsequent application of powder organic coatings
Annex B (informative) Guidance on the influence of steel
        surface chemistry on the surface condition and
        pre-treatment of galvanized or sherardized articles
        prior to application of powder organic coatings
Annex C (informative) Guidance on treatment of hot dip
        galvanized or sherardized articles prior to
        pre-treatment for application of powder organic
        coatings
Annex D (informative) Guidance on pre-treatment of hot
        dip galvanized or sherardized articles prior to the
        application of powder organic coatings
Bibliography

Describes the agreements to be made between the client, the galvanizer/sherardizer, the chemical suppliers and the applicators of the pre-treatment and the powder organic coating systems (if they are not one and the same).