UNI EN 607 : 2005

Foreword
1 Scope
2 Normative references
3 Terms and definitions
   3.1 eaves gutter
   3.2 down-pipe
   3.3 union-clip (gutter-union)
   3.4 joint bracket (union-bracket)
   3.5 gutter adaptor
   3.6 angle
   3.7 stop end
   3.8 outlet
   3.9 commercial length
4 Material
   4.1 Raw material
   4.2 Utilisation of non virgin material
5 General characteristics of profiles - Appearance
6 Geometrical characteristics of profiles
   6.1 Width
   6.2 Length
7 Physical and mechanical characteristics of profiles
8 General characteristics of fittings
   8.1 General
   8.2 Appearance
   8.3 Shape and dimensions
9 Physical characteristics of fittings
10 Gutter sealing rings
11 Solvent cements
12 Designation
13 Marking
14 Fitness for purpose of gutter systems
15 Production control
Annex A (normative) Utilisation of non-virgin material
      A.1 Material definitions
          A.1.1 virgin material
          A.1.2 own reprocessable material
          A.1.3 external reprocessable material
          A.1.4 recyclable material
      A.2 Reprocessable and recyclable material
          A.2.1 Own reprocessable material
          A.2.2 External reprocessable and recyclable
                materials with agreed specification
          A.2.3 External reprocessable and recyclable
                material not covered by an agreed
                specification
Annex B (normative) Impact test
Annex C (normative) Heat reversion test for fittings
Annex D (normative) Watertightness test
Annex E (informative) Cross section areas
Bibliography

Specifies requirements and test methods of eaves gutters and fittings made from unplasticized polyvinyl chloride (PVC-U) and intended to be used for rainwater drainage.