UNI EN ISO 13628-11 : 2008

Foreword
Introduction
1 Scope
2 Normative references
3 Terms, abbreviated terms, definitions and symbols
   3.1 Terms and definitions
   3.2 Symbols and abbreviated terms
4 System, pipe, and component description
   4.1 Introduction
   4.2 Flexible pipe systems
   4.3 Flexible pipe description
   4.4 Ancillary components
5 Pipe design considerations
   5.1 General
   5.2 Design overview
   5.3 Failure modes
   5.4 Design criteria
   5.5 Load cases
6 Materials
   6.1 Scope
   6.2 Materials - Unbonded pipe
   6.3 Materials - Bonded pipe
   6.4 Alternative materials
   6.5 Polymer/elastomer test procedures
   6.6 Metallic-material test requirements
7 System design considerations
   7.1 General
   7.2 General system requirements
   7.3 Flowline design requirements
   7.4 Riser design requirements
   7.5 Ancillary components
   7.6 System interfaces
8 Analysis considerations
   8.1 Introduction
   8.2 Analysis techniques
   8.3 Loads
   8.4 Global-response evaluation
9 Prototype testing
   9.1 General
   9.2 Design programmes
   9.3 Classification of prototype tests
   9.4 Test requirements
   9.5 Test protocol
   9.6 Procedures - Standard prototype tests
   9.7 Procedures - Special prototype tests
10 Manufacturing
   10.1 General
   10.2 Manufacturing - Unbonded pipe
   10.3 Manufacturing - Bonded pipe
   10.4 Marking
   10.5 Storage
11 Handling, transportation, and installation
   11.1 General
   11.2 Handling
   11.3 Transportation
   11.4 Installation
   11.5 Pre-commissioning and commissioning
12 Retrieval and reuse
   12.1 General
   12.2 Retrieval
   12.3 Reuse
13 Integrity and condition monitoring
   13.1 General
   13.2 General philosophy
   13.3 Failure modes and potential pipe defects
   13.4 Monitoring methods
   13.5 Recommendations
Annex A (normative) - Flexible-pipe high-temperature
        end-fitting qualification test
        protocol - Volatile-content polymers
Annex B (normative) - Polyvinylidene fluoride (PVDF)
        coupon crude-oil exposure-test procedure
Annex C (normative) - Flexible-pipe high-temperature
        end-fitting qualification test procedures:
        Low-volatile-content polymers
Annex D (normative) - Polymer coupon crude-oil
        exposure-test procedure
Bibliography

Describes guidelines for the design, analysis, manufacture, testing, installation and operation of flexible pipes and flexible pipe systems for onshore, subsea and marine applications.