14/30253068 DC : 0
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
BS EN ISO 4892-1 - PLASTICS - METHODS OF EXPOSURE TO LABORATORY LIGHT SOURCES - PART 1: GENERAL GUIDANCE
Hardcopy , PDF
31-05-2016
English
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Principle
5 Requirements for laboratory exposure devices
6 Test specimens
7 Test conditions and procedure
8 Periods of exposure and evaluation of test results
9 Test report
Annex A (normative) - Procedures for measuring
the irradiance uniformity in the specimen
exposure area
Annex B (informative) - Factors that decrease
the degree of correlation between artificial
accelerated weathering or artificial
accelerated irradiation exposures and
actual-use exposures
Annex C (informative) - Solar spectral irradiance
standards for daylight
Bibliography
BS EN ISO 4892-1.
Committee |
PRI/21
|
DocumentType |
Draft
|
Pages |
32
|
PublisherName |
British Standards Institution
|
Status |
Superseded
|
SupersededBy |
ISO 293:2004 | Plastics — Compression moulding of test specimens of thermoplastic materials |
ISO 3167:2014 | Plastics Multipurpose test specimens |
ISO 294-3:2002 | Plastics Injection moulding of test specimens of thermoplastic materials Part 3: Small plates |
ISO 295:2004 | Plastics — Compression moulding of test specimens of thermosetting materials |
ISO 294-2:1996 | Plastics Injection moulding of test specimens of thermoplastic materials Part 2: Small tensile bars |
ISO 4892-3:2016 | Plastics — Methods of exposure to laboratory light sources — Part 3: Fluorescent UV lamps |
ISO 4582:2017 | Plastics — Determination of changes in colour and variations in properties after exposure to glass-filtered solar radiation, natural weathering or laboratory radiation sources |
ISO 4892-4:2013 | Plastics — Methods of exposure to laboratory light sources — Part 4: Open-flame carbon-arc lamps |
ISO 4892-2:2013 | Plastics — Methods of exposure to laboratory light sources — Part 2: Xenon-arc lamps |
ISO 294-1:2017 | Plastics — Injection moulding of test specimens of thermoplastic materials — Part 1: General principles, and moulding of multipurpose and bar test specimens |
ISO 2818:1994 | Plastics — Preparation of test specimens by machining |
ISO 9370:2017 | Plastics — Instrumental determination of radiant exposure in weathering tests — General guidance and basic test method |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.