AS 1085.10-2002

1 - AS 1085.10-2002 RAILWAY TRACK MATERIAL - RAIL ANCHORS
4 - PREFACE
5 - CONTENTS
6 - 1 SCOPE
6 - 2 REFERENCED DOCUMENTS
6 - 3 DESIGNATION
7 - 4 DESIGN
7 - 5 BEARING AREA
7 - 6 MATERIAL
7 - 7 HEAT TREATMENT
7 - 8 BRANDING
7 - 9 FINISH
7 - 10 TESTS
7 - 10.1 Mechanical
7 - 10.1.1 Rail
8 - 10.1.2 Rail anchor
8 - 10.1.3 Frequency of test
8 - 10.1.4 Test procedure
8 - 10.1.5 Test requirement
8 - 10.2 Dimensional tolerance
8 - 10.3 Hardness
8 - 10.3.1 Number of tests
8 - 10.3.2 Test requirement
9 - 11 RETESTS
10 - APPENDIX A - PURCHASING GUIDELINES
10 - A1 INFORMATION TO BE SUPPLIED BY THE PURCHASER
10 - A2 INDEPENDENT TESTS
10 - A3 CERTIFICATE OF COMPLIANCE AND TEST CERTIFICATE
10 - A3.1 Certificate of compliance
10 - A3.2 Test certificate
11 - A4 INSPECTION
12 - APPENDIX B - MEANS OF DEMONSTRATING COMPLIANCE WITH THIS STANDARD
12 - B1 SCOPE
12 - B2 STATISTICAL SAMPLING
12 - B3 PRODUCT CERTIFICATION
13 - B4 SUPPLIER'S QUALITY MANAGEMENT SYSTEM
13 - B5 OTHER MEANS OF ASSESSMENT

Specifies requirements for one-piece rail anchors for application to steel rails rolled in accordance with AS1085.1.

This Standard sets out the requirements for one-piece rail anchors for application to steel rails rolled in accordance with AS 1085.1. Dimensions and tolerances are not specified.NOTES: 1 The specified requirements may also be relevant for rail sizes not currently covered by this Standard.2 Dimensional tolerances should be agreed between the purchaser and the manufacturer.3 It is essential that the purchaser supply the manufacturer with certain information when enquiring about, or ordering, rail anchors to this Standard. Purchasing guidelines are given in Appendix A.4 Alternative means for demonstrating compliance with this Standard are given in Appendix B.

Originated as AS 1085.10-1979.
Previous edition AS 1085.10-1995.
Fourth edition 2002.