ASTM C 873/C873M : 2015 : REDLINE
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Test Method for Compressive Strength of Concrete Cylinders Cast in Place in Cylindrical Molds
10-11-2023
English
23-02-2016
Important note : Users cannot be edited or removed once added to your Multi user PDF.CONTAINED IN VOL. 04.02, 2016 Specifies the determination of strength of cylindrical concrete specimens that have been molded in place using special molds attached to formwork.
| Committee |
C 09
|
| DevelopmentNote |
Supersedes ASTM C 873. (03/2008)
|
| DocumentType |
Redline
|
| Pages |
4
|
| PublisherName |
American Society for Testing and Materials
|
| Status |
Superseded
|
| SupersededBy | |
| Supersedes |
1.1This test method covers the determination of strength of cylindrical concrete specimens that have been molded in place using special molds attached to formwork. This test method is limited to use in slabs where the depth of concrete is from 125 to 300 mm [5 to 12 in.].
1.2Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.3This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to consult and establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use. (Warning—Fresh hydraulic cementitious mixtures are caustic and may cause chemical burns to skin and tissue upon prolonged exposure.2)
| ACI 306R : 2016 | GUIDE TO COLD WEATHER CONCRETING |
| ACI 301 : 2016 | SPECIFICATIONS FOR STRUCTURAL CONCRETE |
| ACI 207.3R : 2018 | REPORT ON PRACTICES FOR EVALUATION OF CONCRETE IN EXISTING MASSIVE STRUCTURES FOR SERVICE CONDITIONS |
| ACI ITG-8R : 2010 | REPORT ON PERFORMANCE-BASED REQUIREMENTS FOR CONCRETE |
| ASTM C 39/C39M : 2018 : REDLINE | Standard Test Method for Compressive Strength of Cylindrical Concrete Specimens |
| ACI MNL 3 : 0 | GUIDE TO THE CODE FOR ASSESSMENT, REPAIR, AND REHABILITATION OF EXISTING CONCRETE STRUCTURES |
| ACI 301M : 2016 | SPECIFICATIONS FOR STRUCTURAL CONCRETE |
| ACI PRC-308 : 2016 | GUIDE TO EXTERNAL CURING OF CONCRETE |
| CSA A23.1 A23.2 : 2014 | CONCRETE MATERIALS AND METHODS OF CONCRETE CONSTRUCTION/TEST METHODS AND STANDARD PRACTICES FOR CONCRETE |
| ASTM C 42/C 42M : 2016-10 | TEST METHOD FOR OBTAINING AND TESTING DRILLED CORES AND SAWED BEAMS OF CONCRETE |
| ASTM C 470/C470M : 2015 : REDLINE | Standard Specification for Molds for Forming Concrete Test Cylinders Vertically |
| ASTM C 1231/C1231M : 2015 : REDLINE | Standard Practice for Use of Unbonded Caps in Determination of Compressive Strength of Hardened Cylindrical Concrete Specimens |
| ASTM C 670 : 2015 : REDLINE | Standard Practice for Preparing Precision and Bias Statements for Test Methods for Construction Materials |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.