ASTM D 2852 : 1995 : R2008
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
Standard Specification for Styrene-Rubber (SR) Plastic Drain Pipe and Fittings
11-11-2014
01-03-2008
CONTAINED IN VOL. 10.01, 2017 Defines determination of the thermal endurance of film-insulated round magnet wire in air at atmospheric pressure.
Committee |
F 17
|
DocumentType |
Standard
|
ProductNote |
Reconfirmed 2008 Reconfirmed 2013
|
PublisherName |
American Society for Testing and Materials
|
Status |
Superseded
|
SupersededBy | |
Supersedes |
1.1 This specification covers requirements and test methods for materials, dimensions, workmanship, impact resistance, load-deflection properties, dimensional stability, and joint tightness of plain-end or bell-end styrene-rubber (SR) plastic drain pipe and fittings in sizes 2 through 6 in.
1.2 The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are for information only.
1.3 The following safety hazards caveat pertains only to the test methods portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.
ASTM D 3122 : 2015 | Standard Specification for Solvent Cements for Styrene-Rubber (SR) Plastic Pipe and Fittings |
ASTM F 810 : 2012 : R2018 | Standard Specification for Smoothwall Polyethylene (PE) Pipe for Use in Drainage and Waste Disposal Absorption Fields |
ASTM D 1711 : 2015 : REDLINE | Standard Terminology Relating to Electrical Insulation |
IEC 60172:2015 | Test procedure for the determination of the temperature index of enamelled and tape wrapped winding wires |
IEEE 101 : 1987 | GUIDE FOR THE STATISTICAL ANALYSIS OF THERMAL LIFE TEST DATA |
ASTM D 5423 : 2014 | Standard Specification for Forced-Convection Laboratory Ovens for Evaluation of Electrical Insulation |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.
Logging out.