ASTM E 1268 : 2001 : R2016

1.1This practice describes a procedure to qualitatively describe the nature of banded or oriented microstructures based on the morphological appearance of the microstructure.

1.2This practice describes stereological procedures for quantitative measurement of the degree of microstructural banding or orientation.

1.3This practice describes a microindentation hardness test procedure for assessing the magnitude of the hardness differences present in banded heat-treated steels. For fully martensitic carbon and alloy steels (0.10–0.65 %C), in the as-quenched condition, the carbon content of the matrix and segregate may be estimated from the microindentation hardness values.

1.4This standard does not cover chemical analytical methods for evaluating banded structures.

1.5This practice deals only with the recommended test methods and nothing in it should be construed as defining or establishing limits of acceptability.

1.6The measured values are stated in SI units, which are regarded as standard. Equivalent inch-pound values, when listed, are in parentheses and may be approximate.

1.7This standard does not purport to address all of the safety problems, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.