BS DD16792(2002) : 2002
Superseded
A superseded Standard is one, which is fully replaced by another Standard, which is a new edition of the same Standard.
View Superseded by
TECHNICAL PRODUCT DOCUMENTATION (TPD) - DIGITAL PRODUCT DEFINITION DATA PRACTICES
Hardcopy , PDF
28-09-2007
English
01-01-2002
Important note : Users cannot be edited or removed once added to your Multi user PDF.
Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Product definition data set identification and
control
5 Data set requirements
6 Model requirements
7 Common requirements for product definition data
8 Notes and special notations
9 Model values and dimensions
10 Plus/minus tolerances
11 Datum applications
12 Geometric tolerances
13 Claims of compliance
Annex A (normative) Geometrically controlled profile
symbol
Annex B (normative) Standards applicable to drawings
Annex C (informative) Explanation of terms
Gives requirements for, and references documents applicable to, the preparation and revision of digital product definition data, hereafter referred to as data sets. Also describes exceptions and additional requirements to existing ISO standards for using product definition digital sets or drawings in digital format.
| Committee |
TDW/4
|
| DocumentType |
Draft
|
| Pages |
108
|
| PublisherName |
British Standards Institution
|
| Status |
Superseded
|
| SupersededBy |
| BS 8888:2002 | Technical product documentation (TPD). Specification for defining, specifying and graphically representing products |
| BS 8888:2006 | Technical product specification (TPS). Specification |
| BS ISO 129:1985 | Technical drawings. Dimensioning. General principles, definitions, methods of execution and special indications |
| BS EN ISO 5456-2:1999 | Technical drawings. Projection methods Orthographic representations |
| BS ISO 128-44:2001 | Technical drawings. General principles of presentation Sections on mechanical engineering drawings |
| BS ISO 1101:1983 | Technical drawings. Geometrical tolerancing. Tolerancing of form, orientation, location and run-out. Generalities, definitions, symbols, indications on drawings |
| BS EN ISO 3098-5:1998 | Technical product documentation. Lettering. CAD lettering of the Latin alphabet, numerals and marks |
| BS ISO 128-50:2001 | Technical drawings. General principles of presentation Basic conventions for representing areas on cuts and sections |
| BS EN ISO 11442-1:1996 | Technical product documentation. Handling of computer-based technical information Security requirements |
| BS ISO 10578:1992 | Technical drawings. Tolerancing of orientation and location. Projected tolerance zone |
| BS EN ISO 5457 : 1999 | TECHNICAL PRODUCT DOCUMENTATION - SIZES AND LAYOUT OF DRAWING SHEETS |
| ISO 31-0:1992 | Quantities and units Part 0: General principles |
| BS ISO 128-34:2001 | Technical drawings. General principles of presentation Views on mechanical engineering drawings |
| BS ISO 128-40:2001 | Technical drawings. General principles of presentation Basic conventions for cuts and sections |
| BS EN ISO 3098-0:1998 | Technical product documentation. Lettering. General requirements |
| BS ISO 128-30:2001 | Technical drawings. General principles of presentation Basic conventions for views |
| BS ISO 406:1987 | Technical drawings. Tolerancing of linear and angular dimensions |
| BS EN ISO 5456-3:1999 | Technical drawings. Projection methods Axonometric representations |
| BS ISO 7200:1984 | Technical drawing. Title blocks |
Access your standards online with a subscription
Features
-
Simple online access to standards, technical information and regulations.
-
Critical updates of standards and customisable alerts and notifications.
-
Multi-user online standards collection: secure, flexible and cost effective.