BS EN 10209:2013

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Designation
5 Requirements
6 Tests
7 Identification
8 Packaging
9 Disputes
10 Information to be supplied by the purchaser at the
   time of ordering
Annex A (normative) - Methods for determining the resistance
        to fish scaling of a steel sheet for enamelling
Annex B (normative) - Method for determining mass loss (iron loss)
        due to pickling for steel grades for direct enamelling
        in accordance with 5.4.2
Annex C (normative) - Method for determining the adherence level
        of enamel applied to a steel sheet
Annex D (informative) - Characteristics for the selection of
        enamelling steel grades

Pertains to cold rolled non-coated low carbon steel flat products in rolled widths equal to or over 600 mm and in thicknesses equal to or less than 3 mm, delivered in sheet, wide strip, slit wide strip or cut lengths obtained from slit wide strip or sheet.

This European Standard applies to cold rolled non-coated low carbon steel flat products in rolled widths equal to or over 600 mm and in thicknesses equal to or less than 3 mm, delivered in sheet, wide strip, slit wide strip or cut lengths obtained from slit wide strip or sheet. It does not apply to cold rolled narrow strip (rolling width < 600 mm) nor to cold rolled flat products for which there is a specific standard, in particular the following: cold-rolled low carbon steel flat products for cold forming (EN 10130); cold-rolled non oriented electrical steel sheet and strip delivered in fully processed state (EN 10106); cold rolled electrical non-alloy and alloy steel sheet and strip delivered in the semi-processed state (EN 10341); cold reduced blackplate (EN 10205); steel sheet and strip for welded gas cylinders (EN 10120); cold-rolled uncoated non-alloy mild steel narrow strip for cold forming (EN 10139); cold-rolled structural steels for general purposes; cold-rolled flat products made of high yield strength for cold forming (EN 10268).