BS EN 123800:1997

1 Introduction
    1.1 Scope and object
    1.2 Related documents
2 General
3 Test specimen
    3.1 Capability Approval
    3.2 Quality conformance inspection
4 Relevant specification
5 Characteristics of the printed board
    Table I Basic characteristics
    Table II Additional characteristics
6 Capability test programme
    Table III
7 Quality conformance inspection
    Table IV
8 Test pattern - Test boards
    8.1 General
    8.2 Application of test patterns and test boards
    Table V
    8.3 Structure of test boards
    8.4 Multiple arrangements of the composite test
          pattern
          8.4.1 Examples of multiple arrangements
                  Test board structure, Table VI
                  Figure 3a Layer 1
                  Figure 3b Layer 2
                  Figure 3c Layer 3
                  Figure 3d Layer 4
                  Figure 3f Layer 6
                  Figure 3g
                  Figure 3h
                  Figure 4 L specimen
                  Figure 5 Examples of delamination
                  Figure 6a Methods of reinforcing lands
                  Figure 6b Examples relating to access holes
                  Figure 7 Examples of soldered holes

Defines the characteristics to be assessed and the test methods to be used for capability testing and for quality conformity testing (lot-by-lot and periodic inspection).