BS EN 13063-1:2005

Foreword
1 Scope
2 Normative references
3 Terms and definitions
4 Shapes, dimensions and tolerances
   4.1 Flue liners
   4.2 Insulation
   4.3 Outer wall elements
   4.4 Cleaning and inspection doors
5 Material requirements
   5.1 General requirements for components
   5.2 Safety in use
   5.3 Hygiene, health and environment
   5.4 Cleaning and inspection doors
   5.5 Freeze/thaw resistance
   5.6 Temperature classes
   5.7 Pressure classes
6 Replacement of single components of the system chimney
   6.1 Change of flue liner
   6.2 Change of opening sections
   6.3 Change of insulation
   6.4 Change of jointing materials for inner liners
   6.5 Change of outer wall elements
   6.6 Change of cleaning and inspection doors
7 Designation
8 Product information
9 Marking and labelling
10 Evaluation of conformity
   10.1 General
   10.2 Components
   10.3 Initial type testing of soot fire resistant system
        chimneys
   10.4 Exchange of components
   10.5 Factory production control
Annex A (normative) Test methods
Annex B (normative) Stainless steel outer walls
Annex C (normative) Thermal resistance of the system
                       chimney
Annex D (normative) Sampling procedures for an AQL of
                       10% and inspection level S2
Annex ZA (informative) Clauses of this European Standard
                       addressing the provisions of the EU
                       Construction Product Directive
Bibliography

Defines requirements and test methods for multiwall soot fire resistant system chimneys, working under dry conditions, with corrosion resistance 3, with negative pressure in which the products of combustion are conveyed to the atmosphere through clay/ceramic flue liners.

This European Standard specifies the requirements and test methods for multiwall soot fire resistant system chimneys, working under dry conditions, with corrosion resistance 3, with negative pressure (see EN 1443) in which the products of combustion are conveyed to the atmosphere through clay/ceramic flue liners. Marking and inspection are also covered by this standard. This standard does not apply to structurally independent (free standing or self-supporting) system chimneys. A soot fire resistant system chimney has the following items where appropriate: clay/ceramic flue liners; Insulation layer; outer walls; mortar for jointing flue liners; mortar for jointing outer walls; terminal; chimney base; cladding; opening section; cleaning and inspection door; distance piece; reinforcement. The soot fire resistant chimney covers a combination of compatible chimney components, obtained or specified from one manufacturing source with product responsibility for the whole chimney.