BS EN 60079-19 : 2011

INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 General
5 Additional requirements for the repair and overhaul of
   equipment with type of protection 'd' (flameproof)
6 Additional requirements for the repair and overhaul of
   equipment with type of protection 'i' (intrinsic safety)
7 Additional requirements for the repair and overhaul of
   equipment with type of protection 'p' (pressurized)
8 Additional requirements for the repair and overhaul of
   equipment with type of protection 'e' (increased safety)
9 Additional requirements for the repair and overhaul of
   equipment with type of protection 'n'
10 Additional requirements for the repair and overhaul of
   equipment covered by IEC 60079-26
11 Additional requirements for the repair and overhaul of
   equipment with type of protection Group III 't'(formerly
   know as 'tD' DIP) DIP)pe of protection 'p' (pressurized)
12 Additional requirements for the repair and overhaul of
   equipment with type of protection pressurization 'pD'
Annex A (normative) - Identification of repaired equipment
        by marking
Annex B (normative) - Knowledge, skills and competencies of
        'Responsible Persons' and 'Operatives'
Annex C (normative) - Requirements for measurements in
        flameproof equipment during overhaul, repair and
        reclamation (including guidance on tolerances)
Annex D (informative)
Bibliography
Annex ZA (normative) - Normative references to international
         publications with their corresponding European publications

Provides instructions, principally of a technical nature, on the repair, overhaul, reclamation and modification of equipment designed for use in explosive atmospheres.