BS EN 61014:2003

INTRODUCTION
1 Scope
2 Normative references
3 Terms and definitions
4 Basic concepts
  4.1 General
  4.2 Origins of weakness and failures
      4.2.1 General
      4.2.2 Systematic weaknesses
      4.2.3 Residual weaknesses
  4.3 Basic concepts for reliability growth in product development
      process; integrated reliability engineering concept
  4.4 Basic concepts for reliability growth in the test phase
  4.5 Planning of the reliability growth and estimation of achieved
      reliability during the design phase
      4.5.1 General
      4.5.2 Reliability growth in the product development/design
             phase
      4.5.3 Reliability growth with the test programmes
5 Management aspects
  5.1 General
  5.2 Procedures including processes in the design phase
  5.3 Liaison
  5.4 Manpower and costs for design phase
  5.5 Cost benefit
6 Planning and execution of reliability growth programmes
  6.1 Integrated reliability growth concepts and overview
  6.2 Reliability growth activities in the design phase
      6.2.1 Activities in concept and product requirement phase
      6.2.2 Product definition and preliminary design
      6.2.3 Project design phase
      6.2.4 Tooling, first production runs (preproduction),
             production phase
      6.2.5 Product fielded phase
  6.3 Reliability growth activities in the validation test phase
  6.4 Considerations for reliability growth testing
      6.4.1 General
      6.4.2 Test planning
      6.4.3 Special considerations for non-repaired or one-shot
             (expendable) items and components
      6.4.4 Classification of failures
      6.4.5 Classes of non-relevant failures
      6.4.6 Classes of relevant failures
      6.4.7 Categories of relevant failures that occur in test
      6.4.8 Process of reliability improvement in reliability
             growth tests
      6.4.9 Mathematical modelling of test reliability growth
      6.4.10 Nature and objectives of modelling
      6.4.11 Concepts of reliability measures in reliability
             growth testing as used in modelling
      6.4.12 Reporting on reliability growth testing and
             documentation
7 Reliability growth in the field
Annex ZA (normative) Normative references to international
         publications with their corresponding European
         publications
Bibliography

Describes requirements and gives guidelines for the exposure and removal of weaknesses in hardware and software items for the purpose of reliability growth. Applies when the product specification calls for a reliability growth programme of equipment (electronic, electromechanical and mechanical hardware as well as software) or when it is known that the design is unlikely to meet the requirements without improvement.

Specifies requirements and gives guidelines for the exposure and removal of weaknesses in hardware and software items for the purpose of reliability growth. Applies when the product specification calls for a reliability growth programme of equipment (electronic, electromechanical and mechanical hardware as well as software) or when it is known that the design is unlikely to meet the requirements without improvement. The main changes with respect to the previous edition are listed below. A subclause on planning reliability growth in the design phase has been added. A subclause on management aspects covering both reliability growth in design and the test phase has been added. A clause on reliability growth in the field has been added.