BS EN 682:2002

Foreword
1 Scope
2 Normative references
3 Classification
4 Requirements
   4.1 Materials
   4.2 Finished seal requirements
        4.2.1 Dimensional tolerances
        4.2.2 Imperfections and defects
        4.2.3 Hardness
        4.2.4 Tensile strength and elongation at break
        4.2.5 Compression set in air
        4.2.6 Accelerated ageing in air
        4.2.7 Stress relaxation in compression
        4.2.8 Volume change in liquid B
        4.2.9 Volume change in oil
        4.2.10 Ozone resistance
        4.2.11 Compression set at -15 degree C
5 Test pieces and temperature
   5.1 Preparation of test pieces
   5.2 Test temperature
6 Factory production control
7 Factory product control tests
   7.1 Sampling
   7.2 Routine tests
   7.3 Type tests
8 Storage
9 Designation
10 Marking and labelling
Annex A (informative) Guidance on storage of seals
Annex ZA (informative) Clauses of this European Standard
         addressing the provisions of the EU Construction
         Products Directive
Bibliography

Specifies requirements for elastomeric materials used in seals for supply pipes and fittings, ancillaries and valves at operating temperatures in general from -5 degree C up to 50 degree C and in special cases from -15 degree C up to 50 degree C, for the following: - gaseous fuel (manufactured, natural and liquefied petroleum gas [LPG] in gaseous phase); - hydrocarbon fluids with aromatic content up to 30 % (V/V), including LPG in liquid phase.

This European Standard specifies requirements for elastomeric materials used in seals for supply pipes and fittings, ancillaries and valves at operating temperatures in general from - 5 °G up to 50 °G and in special cases from - 15 °G up to 50 °G, for the following: General applications (see Table 4, type G) gaseous fuel (manufactured, natural and liquefied petroleum gas [LPG] in gaseous phase); hydrocarbon fluids with aromatic content up to 30 % (V/V), including LPG in liquid phase. Special applications (see Table 4, type H) Materials suitable for carrying gaseous fuels containing gas condensates and hydrocarbon fluids of unrestricted aromatic content. General requirements for finished joint seals are also given; any additional requirements called for by the particular application are specified in the relevant product standards taking into account that the performance of pipe joints is a function of the seal material properties, seal geometry and pipe joint design. This European Standard should be used where appropriate with product standards which specify performance requirements for joints. This European Standard is applicable to joint seals for all pipeline materials including iron, steel, copper and plastics. In the case of composite seals requirements in 4.2.8 and 4.2.9 apply only when the materials used for any elastomeric parts come into contact with gaseous fuel or hydrocarbon fluid. Elongation at break, tensile strength, compression set and stress relaxation requirements for materials of hardness categories 80 and 90 apply only when they constitute that part of the seal which participates directly in the sealing function or in long term stability. This standard is not applicable to the following: seals made from cellular materials; seals with enclosed voids as part of their design; seals with requirements of resistance to flame or to thermal stress; seals which contain splices joining pre-vulcanized profile ends.