BS ISO 10368:2006

Foreword
Introduction
1 Scope
2 Normative references
3 Terms and definitions
4 Performance requirements
  4.1 General
  4.2 Requirements
      4.2.1 System components
      4.2.2 Performance function
      4.2.3 Performance constraints
5 System compatibility requirements
  5.1 General
  5.2 Communications protocol
      5.2.1 General
      5.2.2 MMU to MDCU communications
      5.2.3 MDCU to LRCD communications
      5.2.4 MDCU to HRCD communications
  5.3 MMU/Device communications
      5.3.1 Headers
      5.3.2 Other MMU/Device messages
  5.4 Low data rate physical requirements - LDCU to LRCD
      5.4.1 Frequency
      5.4.2 Modulation method
      5.4.3 Baud rate
      5.4.4 Transmission mode
      5.4.5 Injection mode
      5.4.6 Receiver sensitivity
      5.4.7 Non-transmission Impedance
      5.4.8 Bit synchronization
      5.4.9 Carrier setup time
      5.4.10 Out-of-band filtering for HDR compatibility
  5.5 High data rate physical requirements - HDCU to HRCD
      5.5.1 Modulation method - Broad band
      5.5.2 Transmission mode
      5.5.3 Injection mode
      5.5.4 Output/input impedance
      5.5.5 Power density function
      5.5.6 Synchronization method
      5.5.7 Demodulation method
      5.5.8 Receiver sensitivity
      5.5.9 Data link protocol
      5.5.10 Out-of-band filtering requirements for "LDR"
             compatibility
Bibliography

Establishes the information and interfaces required to permit complying central monitoring and control systems used by one carrier or terminal to interface and communicate with complying remote communication devices of differing manufacture and configuration used by other carriers and terminals.

This International Standard establishes the information and interfaces required to permit complying central monitoring and control systems employed by one carrier or terminal to interface and communicate with complying remote communication devices of differing manufacture and configuration used by other carriers and terminals.

The data-logging formats and message protocols outlined in this International Standard apply to all currently available data rate transmission techniques. These formats and protocols also apply to all future techniques designed to be an ISO International Standard-compatible system.

The performance requirements for the monitoring, communication and control system are given in Clause4. The system compatibility requirements are given in Clause5. All sections of this International Standard apply to all implementations, except where specified.